User manual APPLIED ENERGY CT100

[. . . ] I E) The guarantee period for the products used in commercial applications will be limited to 12 months. I F) For the service work to be undertaken free of charge, the work must be only undertaken by Applied Energy Products Limited, or our approved agents. I G) Service under guarantee has no effect on the expiry date. The guarantee on any exchanged parts or product ends when the original guarantee period ends. Selectronic Premier Thermostatic Instantaneous Electronic Shower Handbook Temperature EXCLUSIONS This guarantee DOES NOT cover damage or defects arising from poor or incorrect installation, improper use or lack of maintenance, including build-up of limescale. [. . . ] Repeat this for your ideal setting waiting each time for the temperature to be achieved. There are eleven temperature options when the Operating Mode Templock is set to "Unlocked" which are as follows:- L-1-2-34-5-6-7-8-9-H. Diagram 15 Audible Short Bleep 1 To Decrease Temperature Temperature Selectronic Premier Temperature Lock Press the cooler button once in the centre (Confirmed with a single bleep) The number will change to the new setting i. e. Display will change from digit 6 to digit 5. See Diagram 15 Wait for a few seconds for the shower to decrease the temperature to the new setting. Repeat this for your ideal setting waiting each time for the temperature to be achieved. (Minimum setting is letter L) Please Note!There are eleven temperature options when the Operating Mode Templock is set to "Unlocked" which are as follows:- L-1-23-4-5-6-7-8-9-H. Diagram 16 Warmer Cooler Audible Short Bleeps 3 Start/Stop Normal Operation Diagram 13 Switching OFF When you have finished showering press the start /stop button in the centre. See Diagram 16 (Confirmed with 3 short bleeps) The water will continue to run for a few seconds so that the unit is cooled down ready for the next time the shower is used. While this is happening the display will circle round and round (see Diagram 17). The unit will then switch off automatically. Switch Off Electricity at ceiling / isolating switch. It then works out how many heaters to switch on so that the shower temperature matches the temperature selected by the buttons. The amount of hot water available at the selected temperature is limited by the total power of the heater. The ideal flow rate is calculated and adjusted automatically. The water is turned on and off by the solenoid valve built into the Shower. 14 DIGITAL TEMPERATURE RANGE DISPLAY TEMPERATURE LOCK INDICATOR Temperature Lock Operation This mode is selected on installation to prevent the temperature being set too Hot or too Cold. See section in `Changing the Operating Mode' Page 9. All the controls are the same as previously described. However, the warmer and cooler adjustment is locked to the digit range (Shown in table on Page 9) and the temperature lock light will come on (See Diagram 20). Diagram 21 Temperature Selectronic Premier Temperature Lock Warmer Cooler Automatic Switch Off With temperature lock selected, the shower will automatically switch off after 30 minutes. Near the end of the 30 minutes the shower will START/STOP BUTTON Start/Stop TEMPERATURE CONTROL BUTTONS 15 5. A stabiliser is built into the flow valve to automatically compensate for small fluctuations in water pressure that frequently occur in households. [. . . ] In some winter conditions, when the incoming mains water is particularly cold it may be necessary to select the inner or outer spray pattern only; this will ensure correct operation of the shower with a slightly lower water flow rate. After use it is normal for some water to drip from the spray head for a few moments. This helps prevent scale build up over prolonged use. Shower Accessories :It is recommend that as well as checking the showerhead as detailed above, the shower unit, riser rail, hose etc. [. . . ]