User manual APPLIED ENERGY DT20B

[. . . ] Service and maintenance contracts to suit all requirements. Please ask for details: By telephone on Techline: +44(0) 8709 000430 By fax on Techfax: +44(0) 8709 000530 At the address below Guarantee - Contact your local distributor or Xpelair direct for details. Technical advise and service - Contact your local Xpelair distributor. Applied Energy Products Ltd Morley Way Peterborough PE2 9JJ t 01733 456789 f 01733 310606 www. applied-energy. com Xpelair is a registered trademark of Applied Energy Products Limited. Applied Energy Products reserve the right to alter product specifications or appearance without prior notice. [. . . ] All finishes and diagrams in this booklet are as accurate as printing processes allow. Xvent multipoint ventilation unit Xvent 275 Leaflet Part No. 22750AA (Revision B) Xpelair Multipoint ventilation unit Installation and Operating Instructions PLEASE LEAVE THIS LEAFLET WITH THE FAN, FOR THE BENEFIT OF THE USER A Position of air intake These products are intended for connection to fixed wiring. Check that the electrical rating shown on the products matches the mains supply. WARNING: THIS PRODUCT IS FOR CONNECTION TO 1 PHASE SUPPLY ONLY, DO NOT CONNECT TO 3 PHASE SUPPLY. WARNING: THIS APPLIANCE MUST BE EARTHED. All installations must be supervised by a qualified electrician. Installation and wiring must conform to current IEE regulations (UK), local or appropriate regulations (other countries). If there is damage to the fitted lead this must be replaced by the manufacturer or service agent. If you have any queries before installing these products or after they are installed, call the Xpelair Technical Hotline +44 (0) 8709 000430. Our engineers are there to help during normal office hours (UK only) and may be faxed at all other times on +44 (0) 8709 000530. Detach the appropriate inlet covers after removing the fixing screws. Note: do not detach cover from any inlet not being used. Install the ducting to connect the fan to the air intakes and to the outlet. If the ducting is suspended, ensure that it is adequately supported. Fit intake and outlet grilles as required. If installing in a position where condensation is likely to run back towards the fan, install a condensation trap as near to the fan as possible. 1. Mount the fan, using appropriate fasteners through the mounting holes provided. Attach the ducting over the inlets and outlet and secure it with worm drive clips. 1. Switch off the mains electrical supply and remove fuses. Connect the cable from the isolating switch to the electrical supply wiring. [. . . ] Switch off the mains electrical supply and remove fuses. Connect the cable from the isolating switch to the electrical supply wiring. Refit fuse before turning on the electricity supply. Note: For fixed wiring circuits, the protective fuse for the appliance must not exceed 5A. B N L DOUBLE POLE ISOLATING SWITCH HIGH SPEED FUSE GREEN/YELLOW BLUE BROWN N LOW SPEED CABLE FROM XVENT UNIT L M H BLACK DT20B WIRING INSTRUCTIONS LINK WIRES. BLACK/WHITE DT20B 3 speed when used with an appropriate controller (not supplied). [. . . ]