User manual APPLIED ENERGY DX180

[. . . ] Assemble the three fan body clamps 8 to the fan box 5 using suitable screws. Pass the electrical cables into the fan box 5 through the cable inlet hole and cable grommet. Ensure cable grommet is in place and a tight fit. Tighten up the three screws, until the fan is clamped to the inner wall. [. . . ] (Fixed at approximately 20 minutes). International Guarantee ­ Contact your local distributor or Xpelair direct s Premier DX180H . IMPORTANT · READ ALL THESE INSTRUCTIONS & WARNINGS FULLY BEFORE COMMENCING INSTALLATION. · INSTALLATIONS AND WIRING MUST CONFORM TO CURRENT IEE REGULATIONS (UK), LOCAL OR APPROPRIATE REGULATIONS (OTHER COUNTRIES). IT IS THE INSTALLER'S RESPONSIBILTY TO ENSURE THAT THE APPROPRIATE BUILDING CODES OF PRACTICE ARE ADHERED TO. · A QUALIFIED ELECTRICIAN MUST SUPERVISE ALL INSTALLATIONS. · THESE APPLIANCES ARE INTENDED FOR CONNECTION TO FIXED WIRING · CHECK THAT THE ELECTRICAL RATING SHOWN ON THE FAN MATCHES THE MAINS SUPPLY. · WARNING: THESE APPLIANCES MUST BE EARTHED. · SITE AWAY FROM DIRECT SOURCES OF HEAT (I. E. : GAS COOKERS OR EYE-LEVEL GRILLS) AND NOT WHERE AMBIENT TEMPERATURES ARE LIKELY TO EXCEED 50 OC. · WHEN THE FAN IS INSTALLED IN A ROOM CONTAINING A FUEL BURNING APPLIANCE, PRECAUTIONS MUST BE TAKEN TO AVOID THE BACKFLOW OF GASES INTO THE ROOM FROM THE OPEN FLUE OF THE FUEL BURNING APPLIANCE · ENSURE THAT ALL RELEVANT SAFETY PRECAUTIONS (CORRECT EYE PROTECTION AND PROTECTIVE CLOTHING ETC) ARE TAKEN WHEN INSTALLING, OPERATING AND MAINTAINING THIS FAN. · IF ANY SECTION OF THE DUCTWORK IS POSITIONED HIGHER THAN THE FAN A CONDENSATION TRAP (XCT100) MUST BE FITTED AS CLOSE AS POSSIBLE TO THE FAN · GENERAL GUIDANCE FOR SITING THE FAN SEE "FIG. G". ALWAYS SITE FAN AS HIGH AS POSSIBLE · THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR INFIRM PERSONS. YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THEY DO NOT PLAY WITH THE APPLIANCE If installing in a ceiling (flush mounting) For Ø100mm ducting: 1. Mark a rectangular hole using the dimensions B. Cut the hole, avoiding ceiling joists and buried cables etc. For flat ducting: · This fan can be installed within a 47mm void without the circular spigot 6 (Fig. E). Flat ducting adapter (FDA) available. ) Terminating the ducting Fit an outer grille to the outer wall. For ceiling mounting, use appropriate ancillaries. g s Wire the electrical connections WARNING: THIS APPLIANCE MUST BE EARTHED Switched Operation The fan can be wired with a separate on/off switch. Fan operates at condensation speed when switched on. When switched off, the fan will continue to operate if the humidity level exceeds the set level. Condensation Operation The fan operates at condensation control speed, when the relative humidity exceeds the set level, and turns off when the humidity drops. Preparing the fan for installation 1. Fit the foam tape 9 around the circular spigot 6 (Fig. E). The impeller 2 can be removed to aid access (if required). [. . . ] Refit fuses before turning on electricity supply. For fixed wiring circuits, the protective fuse for the appliance must not exceed 5A. For Australia Only Permanently connected to the supply and a remote switch controls operation. They should be directly wired to the supply through an approved 10A wall mounted surface switch with at least 3mm clearance between contacts. Cleaning 1. [. . . ]