Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual APPLIED ENERGY FR22-30. We hope that this APPLIED ENERGY FR22-30 user guide will be useful to you.
Lastmanuals help download the user guide APPLIED ENERGY FR22-30.
Manual abstract: user guide APPLIED ENERGY FR22-30
Detailed instructions for use are in the User's Guide.
[. . . ] You may only wire one fan to each controller. For the purpose of these instructions current and previous versions of the fans are identified into Type A & Type B, as follows: These installation instructions are for the installation of the controller when used in combination with Xpelair supplied fans. The controller must be installed to fixed wiring. [. . . ] When intended for use in possible chemical corrosive atmospheres, consult our Technical Service Department (Outside the UK contact your local Xpelair distributor). If installed in a shower room or bathroom the controller and isolating switch must be situated so that they cannot be touched by persons making use of the bath or shower. 1 Detach the Fascia from the Mounting Frame by removing the screw covers and two screws (Refer to Fig. 2 Detach the Mounting Frame from the Wall Box by removing the two screws (Refer to Fig. 4 Check that the electrical rating shown inside the controller matches the power supply. 5 Disconnect the earth wire from the Wall Box. 1 Ensure power supply is isolated and fuses are removed. 2 Route the Cable from the Isolating Switch to the point of connection to the power supply. 3 Make all connections within the Isolating Switch in accordance with the manufacturers instructions. 4 Following all local regulations make connection at point of power supply. 5 Make a final check to ensure all earth points are connected and all covers have been correctly replaced on the fan, controller and isolating switch. 6 Replace all fuses , and switch on the power supply. For fixed wiring circuits the protective fuse for the appliance must not exceed 5 amps. for Australia only: These models are permanently connected to the supply & operation is controlled by a remote switch. They should be directly wired to the supply through an approved 10 amp wall mounted surface switch with at least 3mm clearance between contacts. Eye protection must be worn during all drilling & chiselling operations. Check there are no buried Pipes or Cables in the wall or obstructions on the outside e. 3 Fix the Wall Box and Plastic Surround to the wall, using the mounting holes provided. [. . . ] X Do- Make sure that the mains supply is switched off before attempting to make electrical connections or carry out maintenance or cleaning. X UK: The fan is guaranteed against defects for 3 years from the date of purchase. X If you have any problems, contact Xpelair's Head Office at the address shown below. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE APPLIED ENERGY FR22-30
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual APPLIED ENERGY FR22-30 will begin.
