User manual APPLIED ENERGY GXC 6 EC2

[. . . ] GUARANTEE Terms and Conditions for UK & ROI (outside UK & ROI contact your local distributor) We, Applied Energy Products Limited, guarantee this product for residential use only, for the period of 5 years from the date of purchase subject to the following conditions ­ initial 3 years parts and labour, final 2 years parts only. Within the guarantee period we will resolve, free of charge, any manufacturing defects in the product resulting from faulty workmanship or material on condition that:a) The appliance has been correctly installed in accordance with our instructions and is being used on the supply circuit or voltage printed on the rating plate. b) The appliance has been used in accordance with these instructions and has not been tampered with or otherwise subject to misuse, neglect or accident. c) The appliance has been regularly maintained in accordance with these instructions and the airway is unobstructed. [. . . ] E2 for GX6 EC2 / GXC6 EC2 for 2 speed selection operation using a change over switch (COS). If the fan is wired from above, ensure the outer sheath of cable is retained in the labyrinth, see Fig. Refit the back draught shutter/grille assembly by sliding the grille back over the release catches, the catches will locate and secure the grille. Switch off the mains electricity supply and remove fuses. Connect the cable from the isolation switch to the electrical supply wiring. Replace the fuses and switch on the mains electricity supply. For fixed wiring circuits the protective fuse for the appliances must not exceed 5A. Operating the fan 2. Push down firmly on the trickle vent catch until it clicks into position then release the shutter vanes, see Fig. item 6. To fully close the shutters and stop any back draught 4. Pull the trickle vent catch towards you until it clicks into position. Refit the back draught shutter/grille assembly, see "Wire the electrical connections" section, ensuring that the actuator lever is in the "fully down" position. Maintenance A QUALIFIED ELECTRICIAN MUST CARRY OUT ALL CLEANING. NOTE: THE FAN WILL CONTINUE TO OPERATE WITH THE INNER GRILLE REMOVED HENCE IT MUST BE ISOLATED COMPLETELY FROM THE MAINS BEFORE ANY WORK IS CARRIED OUT. Before cleaning, isolate the fan completely from the mains electricity supply. On the GX6 EC2, allow 3 minutes for the impeller to stop rotating and the powered shutter to close. Cleaning on the GXC6 EC2 can begin once the impeller has stopped rotating. Remove the back draught shutter/grille assembly by pressing the release catch located on the side of the unit with a 6mm screwdriver or a coin, whilst pulling the grille forward. To remove the back draught shutter, lay face down and pull the shutter forwards, see Fig. G2. · · These fans can either be single speed operation with a choice between High and Low at installation, or 2 speed operation when installed with a change over switch (COS). The shutters of the GX6 EC2 have a time delay of up to 1 minute on opening and up to 3 minutes on closing. Activated by operation of the switch, the delay ensures quiet operation. 4 9 Installing the switches and cables 1. Check that there are no buried pipes or cables (eg. Electricity, gas, water) behind the switch location (in the wall or above the ceiling). [. . . ] Feed the cable through the rear cable entry. ALWAYS LOCATE THE FAN AS HIGH AS POSSIBLE. AT LEAST 145mm FROM THE EDGE OF THE WALL/WINDOW FRAME TO THE HOLE CENTRE (SEE FIG. LOCATE THE FAN AS FAR AS POSSIBLE FROM AND OPPOSITE TO THE MAIN SOURCE OF AIR REPLACEMENT TO ENSURE AIRFLOW ACROSS THE ROOM (eg. [. . . ]