User manual APPLIED ENERGY SLIM100

[. . . ] Fix the base of the housing (B) in place using the plugs and screws provided. It may also be fixed to the interior of the ceiling using the 2 quickfit. Loosen the screws (4) until the wedges (5) are fully concealed in the housings (6) and can be easily introduced inside the pipe. [. . . ] ELECTRICAL CONNECTION: The unit must be connected to a single phase mains power supply network at the voltage and frequency indicated on the rating plate of the extractor unit. The electrical installation must include a double pole isolating switch with a distance between contacts of at least 3 mm. Make the electrical connection by loosening the screw (2) until the cover (3) is free and connect the power supply cables to the connection strip (E), the blue cable to N and the brown cable to L. Replace the cover (3), fixing it in place with the screw (2) and finally press home the cover (A) until it is firmly held by the clip (7) and the catch (1) (Fig. The appliance must be permanently connected to a fixed electrical supply installation using twin conductor cable of at least 1 mm2 in section and a maximum of 1. 5 mm2. No earth installation is required as the appliance has double insulation. IPX4 NOTE: TIMER and HUMIDITY connection Must he carried out by following the wiring diagram for SL100T / SL100HT / SL150HT. Connect the wires to the connection strip by using a pointed instrument (the tip of a screwdriver for example) to apply pressure to (x) (xl, x2, x3) and pushing the striped wires (L. SL100T IPX4 Adjust the timer by turning the knob (4) in a clockwise direction to increase the operating time (3' ­ 15'). SL100HT and SL150HT IPX4 Adjust the operating time by turning the red knob (4) in a clockwise direction. Adjust the level of humidity by turning the blue knob (5) in a clockwise direction to increase the level. The Slimline HT series incorporate a LED indicator. The LED is lit when the extractor is functioning either activated by the switch fitted to the appliance itself or another, exterior switch. When the extractor is activated by the level of humidity the LED is not lit. When the extractor is not operating the LED does not light. SL100P and SL150P IPX4 This model is fitted with a Start/stop pull-switch (6) (Fig. [. . . ] UK: Xpelair have a comprehensive range of services including: · Free technical advice help-desk from Engineers on all aspects of ventilation · Free design service, quotations and site surveys · Service and maintenance contracts to suit all requirements. Please ask for details: · By telephone on Techline:+44 (0) 8709 000430 · By fax on Techfax:+44 (0) 8709 000530 · At the address below International · Guarantee: Contact your local distributor or Xpelair direct for details. · Technical Advice and Service: Contact your local Xpelair distributor Applied Energy Products Ltd Morley Way Peterborough PE2 9JJ t 01733 456789 f 01733 310606 www. applied-energy. com Xpelair is a registered trademark of Applied Energy Products Limited. [. . . ]