User manual APPLIED ENERGY XPLUS 340

[. . . ] It may be advisable to have the unit inspected by your installer once every 4 or 5 years and cleaned if necessary. For the Installer If you have any queries before installing these products or after they are installed call the Xpelair Technical Hotline +44 (0) 8709 000430. Our engineers are there to help during normal office hours (UK only) and may be faxed at all other times on + 44 (0) 8709 000530. Customers outside the UK please contact your local Xpelair distributor, details of which are available from the UK office. Characteristics The electric motor and fan are enclosed in the ventilator housing. [. . . ] It is a modular system consisting of one or more emitters and one or more receivers. The emitters take the form of a wall-mount switch. Each emitter can control an unlimited number of receivers simultaneously. Each receiver can be controlled by up to 32 emitters. CHARACTERISTICS: · emitter range: 100m in open air · no wiring between control points and receivers (RF controlled), only one connection between the switch-receiver and the device to be operated. · orientation of emitters is not necessary. Transmission of signals through non-metal walls is possible. · the wall-mount emitter can be readily glued or screwed on the wall. · receiver and emitter form one integrated whole · operating temperature: -5°C to +45°C · receiver: max. load 4A / 230V~ 50Hz · emitters + base plate: button with 4 positions = low = middle = high = high with timer short press (<1. 6sec. ) = max. speed for 10 minutes long press (>1. 6sec. ) = max. speed for 30 minutes After this time has elapsed the fan returns to the lowest position. Battery equivalents for emitter: Varta 3V/260mAh CR2430 Panasonic 3V/250mAh CR2330 Putting into service After installing the emitters and receivers, the emitters must be programmed with the receivers. A receiver will only work if the address of an emitter has been programmed in the receiver. PROGRAMMING · Using a fine screwdriver, briefly (< 1. 6 sec) press the flush programming key situated on the receiver on the Xvent unit. · A light signal starts flashing (flashing = 1 sec. ). · Program all (RF) emitters that have to interwork with the receiver one by one. The correct reception of an address is acknowledged by a long light signal (4sec. ). · Up to 32 emitters can be programmed per receiver. When this maximum is reached, the LED will keep flashing. · You can end the programming by briefly (<1. 6 sec) pressing the flush key again. ADDING EMITTERS Additional emitters (max. 32) can at all times be programmed on a receiver. [. . . ] 5 Remove the protection between the battery and the contacts (Fig. D). 6 Fit the control buttons (Fig F) B) Screwing: Mounting on a flush-mounting box on a structured base, e. g. 1 Click the cover plate onto the base plate (Fig. B). 2 Centre the assembly and screw onto the wall using the screws and plugs provided (Fig. E). [. . . ]