User manual APRILIA AM5 H2O AUTOMIX

[. . . ] This manual contains all the main information and the instructions required for normal use and maintenance of your vehicle. For controls and check-ups that cannot be carried out easily with the standard equipment supplied, we advise you to consult our Agents who can assure you of quick and careful servicing. To keep your Aprilia motor-cycle always in perfect operating conditions, we advise you to insist on original spares and to have repairs carried out only by Aprilia Agents and Dealers. When ordering spare parts from the Agent, always quote the spares code which is stamped on a sticker placed under the saddle. [. . . ] 35 lt) and an oil feed pump with variable capacity. (The capacity varies according to the number of revs of the engine and the throttle opening). When the oil reaches reserve level a warning light on the dashboard lights up. The capacity is predetermined in the design phase, so the user never has to make any adjustments. It may be necessary to bleed air from the pump whenever the pump is dismantled, the oil feed hose is detached, or if the lubricant in the oil tank is completely used up. 14) so that the oil drains off, then tighten the screw again. Keep the pump control lever open until all the air bubbles in the carburettor feed hose have completely disappeared. For greater safety we advise using up all The blended fuel in the tank before refilling with premium grade petrol alone. - Adjust the idling speed of the engine, then check That the clearance of the oil pump and the carburettor is the same; if not, regulate the adjuster provided in order to obtain a maximum clearance of 1 mm. Check that there is no throttling in the feed hose and the oil delivery hose; if they are throttled, change them. ($'-8670(17)LJ Set the brake lever at the desired height (A) (in rest position) by means of the adjusting screw (on the lever). Then, with the nut on the pump control rod (B), take up the piston play so that it moves freely and is not locked. Check the brake pad wear, proceeding as follows: - Remove the plastic cover (Pos. The thickness of the friction material must be at least 1. - After the first 500 Km or whenever an excessive increase in the idle stroke of the lever is noticed, the hydraulic system must be bled to get rid of any air bubbles that may have formed. The other end of the tube must be placed in a receptacle to catch the oil (3). Remove the lid of the brake oil pump and check that the level is correct. Pull the control lever slowly and completely (2-3 times). Keeping the lever in pulled position, open the breather valve until oil and any air bubbles can be seen coming out of the tube (2). Close the valve again and release the brake lever. Repeat the operation described above until no more air bubbles can be seen in the oil coming out of the valve. Tighten the valve and remove the tube, being careful not to get oil on the brake pads or the disc. [. . . ] Never close the circuit with material other than the fuse. If it is necessary to adjust the beam height, act on the screw (1-Fig. 38) placed behind the frontal element of the fairing. Turn the screw clockwise if you want to raise the beam, anticlockwise if you want to lower it. [. . . ]