User manual APRILIA DORSODURO 750

[. . . ] We have compiled this booklet to provide a comprehensive overview of your vehicle's quality features. Please, read it carefully before riding the vehicle for the first time. it contains information , tips and precautions for using your vehicle. It also describes features, details and devices to assure you that you have made the right choice. [. . . ] Once the key (2) is inserted, press to close the cap again. To adjust the setting, the shock absorber is fitted with a set screw (1) that adjusts the hydraulic rebound damping, a ring nut that adjusts the spring preloading (2) and a locking ring nut (3). Turn the (1) screw to adjust the shock absorber hydraulic rebound damping. Medium load setting: - (for example, rider with passenger and/ or luggage). Open 17 clicks from fully closed 170 mm (6. Open 12 - 16 clicks from fully closed 170 mm (6. Open 12 - 16 clicks from fully closed 170 mm (6. Push repeatedly on handlebar with the front brake lever pulled to compress the fork completely. The stroke should be soft and there should be no oil marks on the stems. Check the tightening of all the components and the correct operation of the front and rear suspension joints. The front suspension consists of a hydraulic fork connected to the headstock by means of two plates. For vehicle suspension adjustment, each fork stem is fitted with an upper nut (1) for adjusting the spring preload. The left hand stem is also equipped with an upper adjuster screw (2) for adjusting hydraulic rebound damping. - (for example, rider with passenger and/ or luggage). Open 2 - 3 notches from fully closed Open 1 turn from fully closed Open 2 - 3 notches from fully closed Open 2 - 3 notches from fully closed 5 - 1 turns from fully closed Open 0. 5 - 1 turns from fully closed The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 114 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 118 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. Running the engine in is essential to ensure engine durability and correct operation. [. . . ] Wash the chain with fuel oil or kerosene. Maintenance operations should be more frequent if there are signs of quick rust. After washing and drying the chain, lubricate it with spray grease for sealed chains. 0: 1 electronic 1400 ± 100 rpm Multiple-disk, oil-bathed clutch with control on the left side of the handlebar Wet crankcase. [. . . ]