User manual APRILIA RS 50

[. . . ] - Noale (VE) SAFETY WARNINGS The following precautionary warnings are used throughout this manual in order to convey the following messages: Safety warning. When you find this symbol on the vehicle or in the manual, be careful to the potential risk of personal injury. Non-compliance with the indications given in the messages preceded by this symbol may result in grave risks for your and other people's safety and for the vehicle! INFORMATION The operations preceded by this symbol must be repeated on the opposite side of the vehicle. If not expressly indicated otherwise, for the reassembly of the units repeat the disassembly operations in reverse order. [. . . ] Put a container (1) with at least 900 cm> capacity in correspondence with the drain plug (2). Unscrew and remove the filling plug (3). Drain the oil and let it drip into the container (1) for a few minutes. Remove the metal residues from the drain plug (2) magnet. Check and if necessary replace the sealing washer of the drain plug (2). use and maintenance RS 50 45 FRONT WHEEL WARNING The disassembly and reassembly of the front wheel may be difficult for unskilled operators. If necessary, contact an aprilia Official Dealer. If you want to perform these operations personally, keep to the following instructions. While disassembling and reassembling the wheel, be careful not to damage the brake pipes, the discs and the pads. DISASSEMBLY Position the vehicle on the appropriate rear support stand, see p. 43 (POSITIONING THE VEHICLE ON THE REAR ). SUPPORT STAND Position the vehicle on the appropriate front support stand, see p. FRONT SUPPORT STAND Withdraw the brake caliper (2) from the disc, leaving it attached to the pipe (3). CAUTION Never pull the front brake lever after removing the brake caliper, otherwise the caliper pistons may go out of their seats, thus causing the outflow of the brake fluid. In this case consult your aprilia Official Dealer, who will carry out the proper maintenance operation. WARNING Make sure that the vehicle is stable. NOTE To remove the front wheel it is necessary to use the appropriate front and . rear support stands Have someone keep the handlebar steady in running position, so that the steering is locked. Brake caliper screw (1) driving torque: 22 Nm (2. 2 kgm). Unscrew and remove the two screws (1) that fasten the front brake caliper (2). Put a support (4) under the tyre, in such a way as to keep the wheel in its position after loosening it. Lock the wheel pin (5) by means of a spanner. Unscrew and remove the nut (6), taking the washer (7). Wheel nut driving torque (6): 80 Nm (8 kgm). Loosen the screw (8) of the wheel pin clamp. 46 use and maintenance RS 50 Push the wheel pin (5), by carefully acting on the threaded end and using a rubber hammer if necessary. Position the wheel between the fork rods on the support (4). NOTE Check the arrangement of the speedometer drive (10) and of the spacer ring (9), in order to be able to reassemble them correctly. Support the front wheel and extract the wheel pin manually. Remove the wheel by withdrawing it from the front. Take the odometer control cover (12). WARNING Danger of injury. Do not introduce your fingers to align the holes. Move the wheel until its central hole and the holes on the fork are aligned. [. . . ] 00965-4828073 - Email: zed@zedmotorz. com RSA MOTOVELO S. A. MEX APRILIA DE MEXICO, SA. LTD. RP ULTRA BIKERS NETWORK INC. SGP CYCLENET PTE TLD HK AH LAM MOTORCYCLE CO. LTD. RC PERFECT MOTORS COMPANY LIMITED KWT ZED MOTORZ - Div. Of AL-RADWAN INTERNATIONAL GROUP RL ACCESS INTERNATIONAL FOR TRADING SARL. [. . . ]