User manual APRILIA SHIVER 750 ABS

[. . . ] We have compiled this booklet to provide a comprehensive overview of your vehicle's quality features. Please, read it carefully before riding the vehicle for the first time. it contains information , tips and precautions for using your vehicle. It also describes features, details and devices to assure you that you have made the right choice. [. . . ] Engine stop switch (ON - OFF) Lights, warning lights, horn, rear stop light switch and electrical devices Tone wheels Introduce the key (2) in the fuel tank cap lock (3). Turn the key clockwise, pull and open the fuel cap. When using a funnel or any other element, make sure it is perfectly clean. The cap can only be closed if the key (2) is inserted. Once the key (2) is inserted, press to close the cap again. To adjust the setting, the shock absorber is fitted with a set screw (1) that adjusts the hydraulic rebound damping, a ring nut that adjusts the spring preloading (2) and a locking ring nut (3). Once the adjustment is done, screw the ring nut (3). Turn the (1) screw to adjust the shock absorber hydraulic rebound damping. 29 in) Hydraulic brake (clicks from fully closed): 12 Shock absorber preloading: screw 4 turns (clockwise) with reference to SOFT adjustment Hydraulic brake (clicks from fully closed): 9 Rear shock absorber adjustment: rider + passenger + luggage (HARD adjustment) Shock absorber preloading: screw 6/7 turns (clockwise) with reference to SOFT adjustment Hydraulic brake (clicks from fully closed): 6/7 Push repeatedly on handlebar with the front brake lever pulled to compress the fork completely. The stroke should be soft and there should be no oil marks on the stems. Check the tightening of all the components and the correct operation of the front and rear suspension joints. The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 114 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. If necessary, the position of the levers can be personalised. Turn the cam (2) until the adequate position for the pedal (3) is obtained. The distance between the end of the lever (1) and the handgrip (2) can be adjusted by rotating the set screw (3). The MAX and MIN clicks correspond to a lever end-handgrip distance of about 118 mm (4. Push the control lever (1) forward and turn the set screw (3) until the lever (1) is at the desired distance. Running the engine in is essential to ensure engine durability and correct operation. Twisty roads and gradients are ideal to run in engine, brakes and suspensions effectively. This ensures that components operate under both "loaded" and "unloaded" conditions, allowing the engine components to cool. [. . . ] To clean the engine outer parts, use degreasing detergent, brushes and old cloths. anodised or painted aluminium parts such as forks , rims , frame , footrests etc. Should be washed using water and mild soap. Using aggressive detergents may damage the surface treatment of these components. [. . . ]