User manual AQUAMATIC SECTIONAL RECESS BOX

[. . . ] This will be used for bonding the panels together 2 Page 1 STEP 1 PRELIMINARY INSTRUCTIONS This cover housing consists of: Tools & Materials required Side panels, black Drain retainer, black Corrugated drain, white Box Ends, black Wood alignment blocks Tek Screws Plastic panel "H" clip strips Empty bottle for MEK catalyst Cordless drill Measuring tape and marker Level Reciprocal or circular saw Duct tape Rubber mallet MEK catalyst 2" wood screws Site Requirements prior installation Excavate drive end extension 36" beyond track (water) line. Excavate non-drive extension 20" beyond track (water) line. Excavate depth from top of pool panel 16" depth 2" Hydraulic chase from equipment pad to drive end of housing End Panels Side Panels Fig. [. . . ] 8a To prepare to install the end panel of the recess, invert the housing as shown in Fig 8a. Fig. 8b Insert end panel as shown in Fig 8b. Fig. 8c Secure end panel with supplied screws as shown in Fig. The bell end of the drain pipe should extend beyond the end panel on the side where you will achieve positive drainage. The opposite end will need to be capped. 5 Fig. 8d Page 4 STEP 3 MOUNTING RECESS BOX TO PANELS Fig. Once the sectional recess box is assembled, it is ready to be attached to the pool panel. With the supplied screws, attach recess box through the front lip of the box and into the top of the pool panel as shown in Fig. 9b. ** Prior to attaching, make certain you have the correct offset. The drive end must be 30" beyond track (water) line and non-drive 12" beyond track (water) line. It is a good time now, to support the under side of the recess box with back fill. Additional support can also be achieved by using stakes. Prior to final backfilling, make sure the drain is connected and the 2" chase for the hydraulic hoses have been installed. 6 Page 5 STEP 4 STRUCTURAL SUPPORT AND DECK FORMING 2 End Blocks Center Block Fig. 10 There are two end blocks and a varying amount of center blocks; this is dependent on the length of the cover recess. 11 Insert end block at each end as shown in Fig. With the end blocks in place, insert the 2" x 4" as shown in Fig. [. . . ] 16b illustrate the use of a 2" x 6" form-board; however, any dimension form-board can be used to suite your specific requirements. Fig. 16a shows the rear form-board being secured to the end block support. Fig. 16b shows the rear and front formboards installed. [. . . ]