User manual AQUATRONICS MS1500

[. . . ] OWNER'S MANUAL AND INSTALLATION GUIDE MS1500 MARINE HIGH POWER AM/FM STEREO RADIO WITH COMPACT DISC PLA YER, CDC SHUTTLE CONTROLS, AND WIRED REMOTE CAP BILITY A Visit us at www. asaelectronics. com to see our full line of mobile audio and video products. MADE IN CHINA INSTALLATION Preparation Please read entire manual before installation. Before You Start 1. Disconnect negative battery terminal. (consult a qualified technician for instructions) 2. Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started 1. Remove 2 transit screws located on top of the unit. [. . . ] Treble 1. Press SEL three times until "TRB" appears in the display. 2. Press the volume buttons up or down to adjust Treble from -10 to +10. "TRB 00" represents flat response. The treble level will be shown on the display for five seconds or until another function is activated. Balance 1. Press SEL four times until "BAL" appears in the display. 2. Press volume buttons up (right) or down (left) to adjust Balance between the right and leftspeakers from BAL 10R to BAL 10L. "BALL=R" represents an equal balance level between the right and left speakers. The balance position will be shown on the display for five seconds or until another function isactivated. Fader 1. Press SEL five times until "FAD" appears in the display. 2. Press volume buttons up (front) or down (rear) to adjust Fader between the front and rear speakers from FAD 10F to FAD 10R. "FAD F=R" represents an equal balance between the front and rear speakers. 4 5 RADIO OPERATION Seek Tuning ¶Â¶ Press the up or down tuning button momentarily to seek the next strong station in the current band. Manual Tuning ¶Â¶ 1. Press the up or down tuning buttons for more than two seconds to select manual tuning mode. "MANUAL" will appear momentarily on the display. 2. Press the up or down tuning buttons momentarily to move radio frequency up or down one step at a time. 3. Press and hold the up or down tuning buttons to quickly advance to a certain frequency. Release when the desired frequency is reached. If manual tuning is not adjusted for five seconds, the unit will return to Seek tuning mode. "AUTO" will appear momentarily on the display. Band ¶Ò Press BAND to change during radio play to switch between three FM bands and one AM band. "F1", "F2", "F3", or "AM" will appear in the display momentarily to indicate which band is currently selected. frequency spacing is the default, and a switch on the bottom of the chassis allows a change to European spacing. Slide the switch to the desired setting using a small screwdriver blade, then press RESET to activate the change. [. . . ] "S--PAUSE" will appear in the display for five seconds. Scan ¶Û During disc play, press SCN to play the first 10 seconds to each track on the disc. When the desired track is reached, press SCN again to end the scan function and play the selected track. The scan function will also be canceled by activating the repeat or shuffle functions. [. . . ]