User manual ARCAM SOLO MOVIE 2.1

[. . . ] Handbook Manuel Handbuch Handleiding so mo l v ie 2. 1 o safety guidelines CAUTION:To reduce the risk of electric shock, do not remove cover (or back). Refer servicing to qualified service personnel. WARNING:To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated `dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Altering the balance may help to restore the stereo image for an offcentre listening position. Bass This setting boosts the lower frequency components of your music. If your music is not `warm' enough, increase this setting; if your music is `boomy', decreasing this setting may help. Treble This setting changes the relative volume of the higher frequency components of your music. If you feel that percussion items in the music (for example) are being lost, increasing this setting may help. If high frequency sounds are too dominant, decrease this setting. Bass Correction This setting should normally be left on minimum. Bass correction may be used if Solo Movie 2. 1 is connected to limited-frequency-range (`Small') speakers, that cannot reproduce very low frequency sounds. Increasing this setting progressively increases very low frequency bass. This control should not be used at high volumes as it may damage your speakers. Sub Level * This adjusts the level of the SuB (subwoofer, or LFE speaker) pre-amp output relative to the other two channels. Sub level does not apply to headphone output. Sleep Timer This timer allows you to specify a listening period, after which Solo Movie 2. 1 will switch automatically into stand-by. The period can be set in 5-minute intervals, up to 120 minutes (2 hours). FM Mode (This menu item is shown only when the selected source is FM. ) In some weak signal areas, it can be beneficial to force the FM tuner to mono output, as mono requires a much lower signal strength to produce acceptable results. If the signal strength in your area is good, leave this as `stereo'. DAB Setup (This menu item is shown only when the selected source is DAB. ) There are two options under this menu item ­ `Scan' and `Erase settings'. Selecting `Scan' causes Solo Movie 2. 1 to search for new DAB stations. If any are found, then they will be added automatically to the list of available stations. Scanning for new stations does not erase old stations that are no longer transmitted ­ over time, or if you change location, this may lead to you having a number of stations in your list that cannot actually be received. In this case, select `Erase settings', then perform a new scan; when the scan is complete, only stations that are available currently in your area will be shown. Set Preset (This menu item is shown only when the selected source is DAB, FM or AM. ) This allows you to store a radio station that you have tuned in to as a numbered preset (confirm with oK). [. . . ] This unit cannot be used for recording discs. This player is compatible with multi-session discs, but plays only sessions that are closed. File names must not contain blank spaces or special characters (. +/=). A CD-ROM used to compile your files must be ISO 9660 Level 1 or Level 2 compliant. [. . . ]