User manual ARCAM SOLO MUSIC

[. . . ] Handbook Manuel Handbuch Handleiding CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR safety guidelines CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Refer servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated `dangerous voltage' within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Source selection Preset mode indicator Station name Current volume using the radio Transmission details, or other information Searching for stations Pressing the MODE button when the radio is selected as the music source toggles between the two tuning modes of Solo ­ `Preset' or `Tune'. The selected mode is shown briefly on the display. When in preset mode, pressing the or buttons on the remote control ( or on the front panel) selects the previous/next station preset (if these are defined). Note that these buttons have no effect, in preset mode, if no presets are defined. In tune mode, by contrast, pressing these buttons changes the AM/FM tuning frequency or selects the next DAB radio station from the station list. FM/AM To search for new stations, ensure that Solo is in `Tune' mode, as described above. Pressing the or buttons on the remote control ( or on the front panel) for longer than one second engages automatic tuning. Solo searches for a radio station signal of sufficient strength, then stops. To skip to the next station, press one of the buttons again. Automatic tuning is available for both FM and AM. Use the and buttons ( or on the front panel) to select the desired tuning frequency. This can be used for tuning to a specific frequency. It is also useful if you are trying to select a station that is too weak for the auto search mode. DAB Tuning stations in under DAB is different from conventional FM or AM tuning, in that you do not need to know the transmission frequency of the station ­ this is handled for you by Solo. Select DAB as the source, then press the MENU button. Navigate through the menu options (see page 12) until `DAB Setup' is displayed. There are two options under this menu item ­ `Scan' and `Erase settings'. Selecting `Scan' causes Solo to search for new DAB stations. If any are found, then they will be added automatically to the list of available stations. Press MENU for a second time to exit the menu. To select a DAB radio station, press the or buttons on the remote control until the name of the station you want to listen to is displayed. The station will be tuned in automatically after a delay of about two seconds. Programming station presets If you wish, you can store your favourite radio station in one of the preset radio stations supported by Solo. This allows quick access to the station in the future, without the bother of having to re-tune. Solo provides for 30 preset radio stations, which are shared between DAB and FM, or AM and FM (depending on your product configuration). [. . . ] If any are found, then they will be added automatically to the list of available stations. Scanning for new stations does not erase old stations that are no longer transmitted ­ over time, or if you change location, this may lead to you having a number of stations in your list that cannot actually be received. In this case, select `Erase settings', then perform a new scan; when the scan is complete, only stations that are available currently in your area will be shown. Setting the clock and alarm When Solo is in stand-by, press MENU to set the clock or alarms. Use the left and right buttons on the remote control to select the item to change, then use the up and down buttons to change the value. [. . . ]