User manual ARCAM SOLO MUSIC SYSTEM

[. . . ] Handbook Manuel Handbuch Handleiding CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR safety guidelines CAUTION: To reduce the risk of electric shock, do not remove cover (or back). WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘dangerous voltage’ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. [. . . ] Navigate through the menu options (see page 12) until ‘DAB Setup’ is displayed. There are two options under this menu item – ‘Scan’ and ‘Erase settings’. Selecting ‘Scan’ causes Solo to search for new DAB stations. If any are found, then they will be added automatically to the list of available stations. Press MENU for a second time to exit the menu. To select a DAB radio station, press the or buttons on the remote control until the name of the station you want to listen to is displayed. The station will be tuned in automatically after a delay of about two seconds. Programming station presets If you wish, you can store your favourite radio station in one of the preset radio stations supported by Solo. This allows quick access to the station in the future, without the bother of having to re-tune. Solo provides for 30 preset radio stations, which are shared between DAB and FM, or AM and FM (depending on your product configuration). To store a preset, first tune to the radio station you wish to store. To store the station into one of presets 1-9, press and hold the appropriately numbered button on the remote control until the ‘preset saved’ message is displayed. An alternative method, which allows access to the higher-number presets, is pressing the MENU button to enter the Solo configuration menu (described fully on page 12), then navigating through the menu until ‘Store Preset’ is displayed. Using the – and + buttons on the remote control (� or � on the front panel) select the preset number you wish to use for the station. If a preset is in use already, then the name or transmission frequency of the station held in the preset is shown on the bottom line of the display; empty presets are indicated by ‘Empty’ being shown. When the preferred preset number is shown, press OK to store the preset. Note that saving a radio station into a location occupied already will cause the original preset station to be overwritten by the new one. Your presets are retained when Solo is disconnected from the power supply. Selecting station presets Solo must be in preset mode before preset stations can be selected (see above). To cycle through your preset stations, use the or buttons on the remote control (� or � on the front panel). Alternatively, presets can be selected directly by using the numeric keypad on the remote. See page 6 for further information on this option. [. . . ] Alternatively, press OK to enter ‘snooze’ mode; the alarm will re-sound after a 10-minute delay. to cancel snooze-mode , press the power button. Set Preset This menu item is shown only when the selected source is DAB, FM or AM. See the section ‘Programming station presets’ on page 7 for more information. [. . . ]