User manual ARIETE 1339

[. . . ] With regard to this manual Even if the appliances are made in conformity with the European regulatory specifications in force and therefore all potentially hazardous parts are protected. Carefully read these warnings and use the appliance only for the use it is designed for in order to prevent accidents and damage. Keep this manual close by for future consultation. If you should decide to give this appliance to other people, remember to also include these instructions. [. . . ] When the machine is in standby mode, the indicator light of the boiler temperature switch (L) will turn off and turn on a regular basis, showing the operation of the boiler thermostat, which is needed to maintain the best water temperature. It is appropriate, for the first coffee for the next ones, to start the coffee brewing, only when this indicator light is on. How to make coffee with a pod To make the coffee with a pod it is necessary to remove the filter (A), the silicone disc (B) and the powder coffee dripper (C) from the filter holder (A). 1 In the filter holder (A) insert the pods dripper (F) and the pod filter (E) (Fig. 2 Place the pod in the filter ring (Fig. 3 Push the pod towards the bottom of the filter with your fingers (Fig. 4 The pod must be well centred and placed inside the filter. 5 Now it is possible to put the filter holder in its seat. Tighten the filter holder while making sure you have hooked it properly 6 The pod could remain stuck in the upper part of the machine after making the coffee and when removing filter holder. To always have a good coffee, you must purchase pods that show the E. If the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of water could leak from the filter holder. Filling the water tank during use It is recommended to fill the water tank before it is completely empty. Fill the tank up to the "MAX" mark with cool tap water. Place the tank on the machine making sure it is securely inserted in and turn it on again. In the event that the tank remained completely without water, it can happen that air enters the circuit preventing the flow of coffee. To reactivate the machine it will be necessary to turn it off and let it cool. Place a container under the filter holder hooking seat and turn on the machine. press and hold the steam dispensing button (K). Wait until water flows out of the filter holder seat (Fig. Drain at least a cup of water from the coupling seat of the filter holder to reactivate the hydraulic circuit. Release the steam dispensing button to stop the flow of water. At this point the machine will resume normal operation. [. . . ] The coffee is not supplied or flows too slowly. There is little water and the pump Make sure the tank is firmly attached and check that the water Level in the tank is normal. Fill with cool tap water up to the "MAX" level mark. The steam exit hole on the dispen- Unclog any deposits that may have formed in the hole of the Probably an excess amount of Slowly remove and disconnect the filter holder because any ground coffee has been placed in remaining pressure could cause splashes or squirts. [. . . ]