User manual ARP INSTRUMENTS PRO SOLOIST MODEL 2701 SERVICE MANUAL

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 2. Control panel at your orders (p. 2) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 3. [. . . ] Check whether there is any detergent residue on the edges of the dispenser. It is due to this residue that the lid won’t close. Get rid of it and you’ll see that it closes. The rinse aid. This product makes dishes sparkle more as it improves their drying. The rinse aid container is situated on the inside of the appliance door; you should refill it when you see the container is empty by means of indicator light “D”. In models fitted with the “low rinse aid” indicator light, fill it up when the latter comes on or flashes. If you pour too much rinse aid into container and it overflows, clean off all excess using a sponge. A Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. F C D Loading the rinse aid. To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. Select the most suitable wash cycle for the type of load you have placed in the dishwasher. The choice of wash cycle depends on the type of dishes to wash and on how dirty they are. To select the right wash cycle, please consult the wash cycle table on page 6. Apart from making you save time and energy, your dishwasher disinfects your dishes, washing them at a high temperature. D ISHWASHER Choose where you want to install your dishwasher, you can even place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is provided with water supply and drain hoses, which can be directed towards the left or right to facilitate appropriate installation. This dishwasher model can be built under a single worktop (please read the relevant instruction sheet). Levelling. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will help ensure its correct operation. This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. In the event of replacements, use original spare parts only. Connect the cold water supply hose to a 3/4 gas threaded connection taking care to screw it tightly onto the tap. [. . . ] Do not lean or sit on the door wire is not long enough, then when it is open, as this could have it replaced with one of overturn the dishwasher. If the appliance malfunctions, ber that it should be free of turn off the water inlet tap and bends or dangerous kinks. disconnect the plug from the wall socket. Then try consultARISTON DISHWASHER - Instructions for installation and use 9 D ISHWASHER Cleaning and special maintenance Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. [. . . ]