User manual ART SGX NIGHTBASS

[. . . ] SGX NIGHTBASS TABLE OF CONTENTS INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 GETTING STARTED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 CONNECTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Sending all Preset Information Transferring all presets to another NIGHTBASS or a suitable MIDI device is accomplished by selecting the SEND ALL PRESETS value and pressing the Enter button. IMPORTANT NOTE For: RECEIVING Preset and MPT Information To dump MIDI data into the NIGHTBASS from either another NIGHTBASS or an external MIDI device you must make sure that the MIDI channels match. The NIGHTBASS will accept MIDI data at all times regardless of what operating mode it is in. PERFORMANCE MIDI [PM] Performance Midi allows the NIGHTBASS to have up to eight of its parameters per preset controlled simultaneously via MIDI. Selection of the parameter to be controlled, the actual MIDI controller, and the Low and High value of the parameter may be programmed from the front panel. When you are in Preset or Edit Mode, the LCD will inform you of either Performance MIDI or FX ON/OFF information being received and what is being changed. There is also a means to monitor MIDI information being sent to the NIGHTBASS. While you are in the PM Mode you can select the MIDI Monitor utility and verify MIDI data being sent to the device. Refer to the MIDI DataMONITOR section for additional information. A table of MIDI controllers can be found in Appendix E, Tables and Charts. Presets in the NIGHTBASS are set up to be controlled by Performance MIDI via the ART X-15 ULTRAFOOT. See the section "Operating the Multiverb NIGHTBASS with the X-15 ULTRAFOOT" further on in this manual for more information. Don't let MIDI scare you, using Performance MIDI in an ART device is easy. In most cases 20 (especially with an X-15) you virtually plug in and play. But, if you want to program, we've made that easy too. Modification to select the specific values and ranges you want the parameter to cover is done by normal editing. The number displayed in the upper left corner represents the MIDI Controller you are working with. Performance MIDI has four levels of programming information associated with it broken up into 4 screens. The first screen displays the information to define what parameter the assigned MIDI controller will control. The second screen shows which MIDI controller is being used. The LCD will display the MIDI control number and its description (i. e. Incidentally, the default value is MC 4 which happens to be the Left Foot Controller on the X15. [. . . ] Check to make sure the unit has power supplied, all cables are connected correctly and the cables themselves are in working condition. 2) If you find the unit to be at fault, write down a description of the problem including how and when the problem occurs. 3) Call the factory for a Return Authorization (RA) number. 4) Pack the unit in it's original carton or a reasonable substitute. [. . . ]