User manual ARTHUR MARTIN AFD280X

[. . . ] Built in modules so that only small parts need replacing at service. Fläkten kan förses med ett TVÄTTBART högeffektivt kolfilter. Ventilatoren kan utstyres med et meget effektivt, VASKBART kullfilter. Emhætten kan monteres med vaskbart højeffektivt kulfilter. Liesituulettimessa voidaan käyttää PESTÄVÄÄ korkeatehoista hiilisuodatinta. [. . . ] It is essential that the grease filter is regularly cleaned to avoid fat to drip on to the hot zone and cause fire. Read also the part Maintenance and Cleaning in the instruction book. Disposal Prevent accidents when disposing your cooker hood. Disconnect the power plug from the wall socket and cut the power cord at the hood inlet. Contact your local authority for information on where to dispose the cooker hood. 31 Description of the cooker hood The cooker hood Control panel Work light Duct Motorhouse Grease filter Accessories The following are included with the cooker hood: Template for mounting: Template for mounting on wall and under cupboard (printed on packaging). Mounting set: 4 pcs 4x60 mm screws, 4 pcs 5x30 mm screws, 4 pcs M5x30 mm screws, 4 pcs 5, 3x15 mm washers, 4 pcs 5, 3x10 mm washers, 4 pcs M5 mm nuts, 4 pcs spacers, 4 pcs 10 mm wall dowels, 4 pcs locknuts, 4 pcs plastic covers, 2 pcs brackets. Following is ordered from retailer: Venting kit: When the cooker hood is to be connected to an evacuation channel use the venting kit containing one ventilation pipe, one roof connecting metal flange and two clamps. LONG LIFE carbon filter: The carbon filter is to be used when the hood is connected to the recirculation system. For new installations: PNC 391 834 201 (50 cm), 391 834 200 (60/70 cm). 3 years): PNC 391 837 001 (50 cm), 391 837 000 (60/70 cm). Venting grid: Venting grid for recirculation. PNC 391 433 101. Functions There are two possible systems: Extraction of air to outside using optional venting kit and evacuation duct. Note that a dishwasher may discolour the filter. Fig. A clean filter minimises the motor load, which helps the fan to function more efficiently. 33 Cleaning the motor cover It is also possible to clean the motor cover (Fig. Remove the inlet ring (A) by turning it anticlockwise. Remove the fan wheel by unscrewing the centre nut (B) on the fan wheel. Clean all the plastic and metal parts with warm water and washing dergent. 2 Changing the light Turn off the power before changing the light. Remove the lampglass by pushing the two snaps forwards (Fig. Replace the damaged part with one of equal rating. To remove the light without damaging it, place a finger on the end of the light and pull gently. A A Cleaning/changing the carbon filter Unlike other carbon filters, the LONG LIFE carbon filter can be cleaned and reactivated. The filter should be cleaned every other month if used normally. The filter is best cleaned in a dishwasher at the highest temperature using normal washer detergent. [. . . ] 9). Min 40 cm Position The cooker hood should be mounted freely hanging on the wall. The cooker hood must be at least 40 cm above electric burners or electric range (Fig. The cooker hood is not approved for mounting above gas burners or gas range. Fig. 5 Electrical connection The electric outlet should be placed above the cooker hood or inside a wall cupboard. [. . . ]