User manual ARTHUR MARTIN ALM4500XX

[. . . ] For the safety of life and property keep the precautions of these user's instructions as the manufacturer is not responsible for damages caused by omission. During manufacture, this appliance has been built in accordance with the standards, directives and/or regulations applying to its use on French territory. For the safety of person and property, as well as out of respect for the environment, you should first read carefully the following recommendations before making any use of your appliance. To avoid any risk of damage to the appliance, transport it in its operating position and with its packing blocks in place (depending on the model). [. . . ] The materials used on this appliance marked by the symbol are recyclable. Operation Switching on Insert the plug into the wall socket. turn the Temperature regulator clockwise to a medium setting. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature regulator toward higher settings to obtain the maximum coldness. a medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened 3) If a water connection is foreseen 6 electrolux · The quantity of food stored · The location of the appliance. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. First use Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. [. . . ] To change the opening direction of the door, do these steps: 1. Open the door with the appliance in the upright position. Unscrew the screws and remove the upper door plastic trim. Remove the little plastic cover (d) from the door plastic trim and install on the opposite side. [. . . ]