User manual ASKO 1885 QUICK START GUIDE

[. . . ] (Recommend 130° F) Rinse To rinse dishes that you plan to wash later that day. Plate warm Warms plates by activating the heating element. Options Delay Each press of this touchpad delays the start by one hour, up to 12 hours. The number of hours selected is displayed in the LED window. After you select the hours, press Start. [. . . ] Make sure there is rinse aid in the dispenser. Add automatic dishwashing detergent and close the dispenser cover. Select the desired wash program and option(s). A red light appears above the selected touchpad(s). The dishwasher will start. Refer to this page in the Use & Care Guide. 3, 4 3 5, 6 4, 5 AMOUNT OF DISHWASHING DETERGENT TO USE We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed for a normal wash load. More heavily soiled items, however, may need more detergent. Also, the amount of detergent needed can vary due to differences in water hardness. The harder the water, the more detergent you may need. (See page 5. ) In any case, you should never use more than three tablespoons of detergent. WINDOW DISPLAY LED WINDO W DISPLAYS empera ture Temper a tur e Settings The wash programs (except Rinse) have water temperature options, as shown in the table below. The LED displays the temperature selections in degrees Celsius. The table below gives both the Celsius and Fahrenheit temperatures. Once you select a temperature, it will remain selected until you change it (except the Light and Quick wash programs, which revert to 130° F). We recommend that you use the lower temperature settings whenever possible to conserve energy. Wash Program Pans, Super & Normal Light & Quick 55° C (130° F) 45° C (110° F) Temperature Options 65° C (150° F) 55° C (130° F) 70° C (160° F) 65° C (150° F) 75° C (170° F) Program Time When a program starts, the LED displays the time it took that program to run last time. As the program runs, the LED displays the remaining time. If the time exceeds an hour, the display alternates between the hour and minutes remaining. The hour is designated by an h (e. g. , 1h). The program times may not always be the same because of variations in the household hot water temperature. The dishwasher heats the water to the proper temperature for the program selected, so if the temperature of the water entering your dishwasher is too low, the dishwasher will run longer because it takes longer to heat the water. [. . . ] If all of the lights on the control panel flash in sequence, this means the machine has detected an overfill. (See page 7. ) Should this happen, call the ASKO Advisory Center. COMMONLY QUESTIONS COMMONLY ASKED QUESTIONS 1) 2) 3) 4) 5) 6) Why does my dishwasher run so long?How do I know when the dishwasher is done?Why am I getting a white film on my dishes? [. . . ]