User manual ASKO 8005 QUICK START GUIDE

[. . . ] It is important that you select the appropriate program for the type of load you are drying. Refer to the table below for recommendations. Program Extra dry (P1) Dry (P2) Normal dry (P3) Iron dry (P4) Timed Dry Air Fluff NOTE: Definition For items that are extremely difficult to dry, such as jeans and thick towels. Cotton w/out elastic and/or decorative trim. [. . . ] Cotton w/out elastic and/or decorative trim. Cotton with elastic and/or decorative trim, linen (white and colorfast). Synthetics, polyester, cotton/polyester blends. (See note below. ) This setting does not heat. It simply circulates the air as the dryer tumbles to shake out the dust and refresh the clothes. (See note below. ) When using Timed Dry and Air Fluff, you must set the number of minutes for the program to run. (See "Time" in the "Option Buttons" section on the next page for details. ) When using Timed Dry, it is best to use a shorter time; then if the load isnt' dry, you can set the time for a few more minutes. QUICK START PROCEDURES 1. Press the Power button to turn on the machine. Check that the door is clear of laundry then close it firmly. (The door won't shut if it's slammed. ) Turn the Program knob to the desired program. This button lets you set a Normal cool-down cycle (15 minutes) or a Quick cool-down (5 minutes). The indicator light will stay lit when Quick is selected. NOTE: The dryer is programmed to retain the option settings last selected with each program. Anti-crease Delayed Start Temperature Buzzer Cool-down UNDERSTANDING THE LED WINDOW The LED window displays the program number for the automatic programs (i. e. , P1 = Extra Dry; P2 = Dry; P3 = Norma Dry; P4 = Iron Dry). When you select Timed Dry, the LED displays the number of mintues selected plus the cool-down time. When you select Air Fluff, the LED displays the number of minutes selected. With Timed Dry and Air Fluff, as the program advances the LED displays the remaining time. "End" on the LED indicates the program is complete. "C" indicates the program is in the cool-down cycle. CLEANING THE LINT . ILTER Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the steps below: 1. Grasp the handle and pull it toward you. [. . . ] "C" indicates the program is in the cool-down cycle. CLEANING THE LINT . ILTER Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to ensure maximum air flow and prevent possible overheating. To clean the filter, follow the steps below: 1. Grasp the handle and pull it toward you. Remove the filter from the holder by pulling it up. [. . . ]