User manual ASKO D1776 QUICK START GUIDE

[. . . ] To select a wash program or the heat dry option, simply press the appropriate touchpad. When you press a touchpad, a red indicator light at the upper left of the touchpad glows to show that you selected that program. Touchpad Controls Press one of these touchpads to select a program or option. Indicator Lights These lights glow red to indicate which program you have selected. LED Window The LED window displays water temperature, program run time and fault codes. PROGRAMS Your ASKO dishwasher has three wash programs, a rinse and hold option and a heat fan dry option. Press the touchpad to select the desired program and option. Pots and pans For the heaviest soiled loads, such as pots, pans, casseroles, etc. [. . . ] Add automatic dishwashing detergent and close the dispenser cover. (See "Amount of Dishwashing Detergent to Use" below. ) 5. Press the touchpad for the desired program and, if desired, the Heat dry option. The red indicator light for the program you select will come on and the dishwasher will start. Refer to this page in the Use & Care Guide. 3, 4 3 5, 6 4, 5 LED WINDOW DISPLAYS Program Time When a program starts, the LED displays the time it took that program to run last time. As the program runs, the LED displays the remaining time. If the time exceeds an hour, the display alternates between the hour and minutes remaining. The hour is designated by an h (e. g. , 1h). The program times may not always be the same because of variations in the household hot water temperature. The dishwasher heats the water to the proper temperature for the program selected, so if the temperature of the water entering your dishwasher is too low, the dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times. If this doesn't help, call the ASKO Advisory Center. Fault Codes The LED window displays three fault codes, as illustrated below. Indicates high water level in the machine. NOTE: When the LED displays three dashed lines, this simply means the door isn't closed completely. Indicates a thermistor fault (heater control). This simply means the door isn't closed completely. AMOUNT OF DISHWASHING DETERGENT TO USE We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed for a normal wash load. More heavily soiled items, however, may need more detergent. Also, the amount of detergent needed can vary due to differences in water hardness. [. . . ] You may be using too much detergent or washing your dishes in water that is too hot. Try using less detergent and use the Normal or Quick wash programs. It's normal to have some water left in the sump area near the drain. If the water fills more than the drain area, see page 9 for possible solutions. [. . . ]