User manual ASROCK 775I65PE-M

[. . . ] In case any modifications of this manual occur, the updated version will be available on ASRock website without further notice. You may find the latest memory and CPU support lists on ASRock website as well. 3u (10/100 Ethernet), supports Wake-On-LAN Hardware Monitor: CPU temperature sensing, Chassis temperature sensing, CPU overheat shutdown to protect CPU life (ASRock U-COP)(see CAUTION 4), CPU fan tachometer, Chassis fan tachometer, Voltage monitoring: +12V, +5V, +3. 0 ports on the rear panel, plus two headers to support 2 additional USB 2. [. . . ] Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock. Secure excess cable with tie-wrap to ensure cable does not interfere with fan operation or contact other components. If you press down the fasteners without rotating them clockwise, Please make sure to disconnect power supply before adding or removing DIMMs or the system components. The DIMM only fits in one correct orientation. It will cause permanent damage to the motherboard and the DIMM if you force the DIMM into the slot at incorrect orientation. Firmly insert the DIMM into the slot until the retaining clips at both ends fully snap back in place and the DIMM is properly seated. PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI interface. aGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot has a special design of clasp that can securely fasten the inserted graphics card. 3V AGP card on the AGP slot of this motherboard!For the voltage information of your AGP card, please check with the AGP card vendors. STEP 1: Before installing the expansion card, please make sure that the power supply is switched off or the power cord is unplugged. Please read the documentation of the expansion card and make necessary hardware settings for the card before you start the installation. STEP 2: Remove the system unit cover (if your motherboard is already installed in a chasis). STEP 4: Align the card connector with the slot and press firmly until the card is completely seated on the slot. STEP 5: Fasten the card to the chassis with screws. The illustration shows how jumpers are setup. The illustration shows a 3-pin jumper whose pin1 and pin2 are "SHORT" when jumper cap is placed on these 2 pins. Note: To select +5VSB, it requires 2 Amp and higher standby current provided by power supply. 22) Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel audio connectors can work. Note: CLRCMOS0 allows you to clear the data in CMOS. the data in CMOS includes system setup information such as system password , date , time , and system setup parameters. [. . . ] If you wish to enter the BIOS Setup Utility after POST, please resume the system by pressing <Ctl> + <Alt> + <Delete>, or pressing the reset button on the system chassis. The Support CD that came with the motherboard contains necessary drivers and useful utilities that will enhance motherboard features. To begin using the Support CD, insert the CD into your CD-ROM drive. "LGA 775 CPU Installation Live Demo" This motherboard is equipped with Intel LGA 775 socket, which is a new CPU socket interface that Intel has released. [. . . ]