User manual ASROCK FM2A75M-DGS R2.0

[. . . ] Copyright Notice: No part of this installation guide may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc. Products and corporate names appearing in this guide may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe. Disclaimer: Specifications and information contained in this guide are furnished for informational use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this guide. [. . . ] Please be noted that the password, date, time, user default profile, 1394 GUID and MAC address will be cleared only if the CMOS battery is removed. If you clear the CMOS, the case open may be detected. Please adjust the BIOS option “Clear Status” to clear the record of previous chassis intrusion status. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!15) SATA_5 SATA_6 These six Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. SATA_1 SATA_2 SATA_3 Serial ATA (SATA) Data Cable (Optional) SATA_4 Either end of the SATA data cable can be connected to the SATA3 hard disk or the SATA3 connector on this motherboard. 0 ports on the I/O panel, there are two USB 2. 0 (19-pin USB3_2_3) ports on the I/O panel, there is (see p. 23) This is an interface for the front panel audio cable that allows convenient connection and control of audio devices. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instruction in our manual and chassis manual to install your system. If you use AC’97 audio panel, please install it to the front panel audio header as below: A. You don’t need to connect them for AC’97 audio panel. For Windows® 8 / 8 64-bit / 7 / 7 64-bit / VistaTM / VistaTM 64-bit OS: Go to the "FrontMic" Tab in the Realtek Control panel. 28) This motherboard supports CASE OPEN detection feature that detects if the chassis cover has been removed. This feature requires a chassis with chassis intrusion detection design. 0 Motherboard 11 English System Panel Header (9-pin PANEL1) This header accommodates several system front panel (see p. Connect the power switch, reset switch and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. PWRBTN (Power Switch): Connect to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch. RESET (Reset Switch): Connect to the reset switch on the chassis front panel. [. . . ] Please make sure to use Windows® VistaTM 64-bit (with SP1 or above), Windows® 7 64-bit or Windows® 8 64-bit. (“xxx” is the device which contains your Windows® installation files. ) You can also press <F11> to launch boot menu at system POST and choose the item “UEFI:xxx“ to boot. 0 Motherboard 53 English Installing OS on a HDD Larger Than 2TB in RAID Mode This motherboard is adopting UEFI BIOS that allows Windows® OS to be installed on a large size HDD (>2TB). [. . . ]