User manual ASROCK H61M-VS4

[. . . ] With respect to the contents of this guide, ASRock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose. In no event shall ASRock, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages (including damages for loss of profits, loss of business, loss of data, interruption of business and the like), even if ASRock has been advised of the possibility of such damages arising from any defect or error in the guide or product. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Do not force to insert the CPU into the socket if above situation is found. Otherwise, the CPU will be seriously damaged. Disengaging the lever by depressing down and out on the hook to clear retention tab. It is recommended to use the cap tab to handle and avoid kicking off the PnP cap. This cap must be placed if returning the motherboard for after service. Hold the CPU by the edges where are marked with black lines. Locate Pin1 and the two orientation key notches. Orientation key notch Pin1 alignment key For proper inserting, please ensure to match the two orientation key notches of the CPU with the two alignment keys of the socket. Carefully place the CPU into the socket by using a purely vertical motion. While pressing down lightly on load plate, engage the load lever. For proper installation, please kindly refer to the instruction manuals of your CPU fan and heatsink. Before installing the expansion card, please make sure that the power supply is switched off or the power cord is unplugged. Please read the documentation of the expansion card and make necessary hardware settings for the card before you start the installation. Remove the system unit cover (if your motherboard is already installed in a chassis). Align the card connector with the slot and press firmly until the card is completely seated on the slot. Fasten the card to the chassis with screws. With the internal VGA output support (DVI-D, D-Sub and HDMI), you can easily enjoy the benefits of dual monitor feature without installing any add-on VGA card to this motherboard. This motherboard also provides independent display controllers for DVI-D, D-Sub and HDMI to support dual VGA output so that DVI-D, D-sub and HDMI can drive same or different display contents. To enable dual monitor feature, please follow the below steps: 1. If you have installed onboard VGA driver from our support CD to your system already, you can freely enjoy the benefits of dual monitor function after your system boots. Repeat steps A through C for the display icon identified by the number three and four. Click and drag the display icons to positions representing the physical setup of your monitors that you would like to use. [. . . ] Though this motherboard provides 24-pin ATX power connector, it can still work if you adopt a traditional 20-pin ATX power supply. To use the 20-pin ATX power supply, please plug your power supply along with Pin 1 and Pin 13. Please connect an ATX 12V power supply to this connector. Though this motherboard provides 8-pin ATX 12V power connector, it can still work if you adopt a traditional 4-pin ATX 12V power supply. [. . . ]