User manual ASROCK H77TM-ITX

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ASROCK H77TM-ITX. We hope that this ASROCK H77TM-ITX user guide will be useful to you.

Lastmanuals help download the user guide ASROCK H77TM-ITX.


Mode d'emploi ASROCK H77TM-ITX
Download
Manual abstract: user guide ASROCK H77TM-ITX

Detailed instructions for use are in the User's Guide.

[. . . ] H77TM-ITX B75TM-ITX H61TM-ITX User Manual Version 1. 0 Published January 2013 Copyright©2013 ASRock INC. All rights reserved. 1 Copyright Notice: No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners’ benefit, without intent to infringe. Disclaimer: Specifications and information contained in this manual are furnished for informational use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this manual. [. . . ] The USB 3. 0 header can support two USB 2. 0 ports. Dummy GND GND IntA_PB_SSTX+ IntA_PB_D+ IntA_PB_D- IntA_PB_SSTX- GND GND IntA_PB_SSRX+ IntA_PB_SSRX- Vbus Vbus Consumer Infrared Module Header (7-pin CIR1) (see p. 13/15/17, No. 5) CIR input +5VA Learn-in LED 1 This header can be used to connect the remote controller receiver. +5VA NC GND 31 Front Panel Audio Header (9-pin HD_AUDIO1) (see p. 13/15/17, No. 26) 1 GND PRESENCE# MIC_RET OUT_RET This is an interface for the front panel audio cable that allows convenient connection and control of audio devices. OUT2_L J_SENSE OUT2_R MIC2_R MIC2_L 1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the instructions in our manual and chassis manual to install your system. If you use an AC’97 audio panel, please install it to the front panel audio header by the steps below: A. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L. MIC_RET and OUT_RET are for HD audio panel only. You don’t need to connect them for AC’97 audio panel. For Windows® XP / XP 64-bit OS: Select “Mixer”. For Windows® 8 / 8 64-bit / 7 / 7 64-bit / VistaTM / VistaTM 64-bit OS: Go to the “FrontMic” Tab in the Realtek Control panel. Adjust “Recording Volume”. Analog Surround Audio Header (17-pin HD_AUDIO2) (see p. 13/15/17, No. 27) 2 1 PIN Signal Name 18 SENSE 16 LFE 14 A_GND 12 Surr_Rear_R 10 A_GND 8 Surr_Side_R 6 A_GND 4 Front_R 2 A_GND PIN Signal Name 17 KEY 15 A_GND 13 Center 11 A_GND 9 Surr_Rear_L 7 A_GND 5 Surr_Side_L 3 A_GND 1 Front_L 32 3W Audio AMP Output Wafer Header (4-pin SPEAKER1) (see p. 13/15/17, No. 28) 1 Front_RFront_R+ Front_L+ Front_L- Please connect the chassis speaker to this header. Power LED Header (3-pin PLED1) (see p. 13/15/17, No. 11) PLEDPLED+ PLED+ 1 Please connect the chassis power LED to this header to indicate system power status. The LED is on when the system is operating. The LED is off in S4 state or S5 state (power off). Chassis Fan Connector (4-pin CHA_FAN1) (see p. 13/15/17, No. 4) FAN_SPEED_CONTROL FAN_SPEED +12V GND 1 2 3 4 Please connect a fan cable to the fan connector and match the black wire to the ground pin. CPU Fan Connectors (4-pin CPU_FAN1) (see p. 13/15/17, No. 22) FAN_SPEED_CONTROL FAN_SPEED +12V GND 4 3 2 1 Though this motherboard provides a 4-Pin CPU fan (Quiet Fan) connector, 3-Pin CPU fans can still work even without fan speed control. If you plan to connect a 3-Pin CPU fan, please connect it to Pin 1-3. Serial Port Header (10-pin COM1) (see p. 13/15/17, No. 18) COM PWR/DCD RXD TXD DTR GND 1 DSR RTS CTS COM PWR/RI NC This COM1 header supports a serial port module. 33 HDMI_SPDIF Header (2-pin HDMI_SPDIF1) (see p. 13/15/17, No. 25) 1 GND SPDIFOUT This header provides SPDIF audio output to HDMI VGA cards, allowing the system to connect HDMI Digital TV/projector/LCD devices. [. . . ] [Fast]: When selecting “Fast”, it is not allowed to boot from a USB storage device. [Ultra Fast]: There are a few restrictions 1. Only supports Windows 8 UEFI operating system 2. You will not be able to enter BIOS Setup by using the keyboard. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ASROCK H77TM-ITX

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ASROCK H77TM-ITX will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag