User manual ASROCK P4VT8+

[. . . ] P4VT8+ User Manual Version 1. 0 Published January 2004 Copyright©2004 ASRock INC. All rights reserved. 1 Copyright Notice: No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, except duplication of documentation by the purchaser for backup purpose, without written consent of ASRock Inc. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. Disclaimer: Specifications and information contained in this manual are furnished for informational use only and subject to change without notice, and should not be constructed as a commitment by ASRock. ASRock assumes no responsibility for any errors or omissions that may appear in this manual. [. . . ] STEP 5: Select RAID 0 for performance from the menu and press <Enter>. From this point, you may choose to auto-configure the RAID array by selecting Auto Setup for Performance or manually configure the RAID array for striped sets. Please continue with the next step if you want to manually configure the RAID array, otherwise, proceed to step #5. 3. 5. 1 Select the option Select Disk Drives, then press <Enter>. Use arrow keys to select disk drive(s), then press <Enter> to mark selected drive. An asterisk is placed before the selected drive. 5. 2 Select the option Block Size, then press <Enter> to set array block size. A list of valid array block sizes are displayed on a pop-up menu. Use arrow keys to move selection bar on items and press <Enter> to select. 5. 3 Select the option Start Create Process and press <Enter> to setup hard disk for RAID system. Then the confirmation message appears: The data on the selected disks will be destroyed. (Y/N) Press <Y> to confirm or <N> to return to the configuration options. 19 2. 9. 2. 2 Guide to Configure RAID 1 Please enter "VIA Tech RAID BIOS Utility" to set RAID 1 configuration. STEP 2: During POST press <Tab> key to enter "VIA Tech RAID BIOS Utility". STEP 3: Start the configuration from the option Create Array. Select the option Create Array, then press <Enter> key. STEP 4: Select the option Array Mode, then press <Enter> key to display the pop-up menu of RAID system setting. STEP 5: Select RAID 1 for data protection from the menu and press <Enter>. 5. 1 Select the option Select Disk Drives, then press <Enter>. Use arrow keys to select disk drive(s), then press <Enter> to mark selected drive. An asterisk is placed before the selected drive. 5. 2 Select the option Start Create Process and press <Enter> to setup hard disk for RAID system. Then the confirmation message appears: Save the data on source disk to mirror after creation? [. . . ] Select [Auto] will enable this feature if the system supports it. Repost Video on STR Resume: This feature allows you to repost video on STR resume. It is recommended to enable this feature under Microsoft® Windows® 98 / ME. Restore on AC/Power Loss: This allows you to set the power state after an unexpected AC/power loss. [. . . ]