User manual ASTON THERMICA EURO 32 SCHEMA

[. . . ] 7th Permutations (nPr) and combinations (nCr). 8th Multiplication, implied multiplication, division. 10th Conversions (A bÌcÍdÌe, 4F, 4D, 4%, 4DMS). 11th < completes all operations and closes all open parentheses. %~?ON >}RQ General Information Examples: See the last page of these instructions for keystroke examples that demonstrate many of the TI-34 Ö functions. [. . . ] Entries with unit modifiers are interpreted accordingly, overriding the Angle mode. To convert an entry: ¦ Set the Angle mode to the unit you want to convert to. Then use a unit modifier to designate the unit to convert from. (Angles of trigonometric functions convert values inside parentheses first. ), or ¦ Select 4DMS, which converts an entry to DMS (Ä Å Æ) notation. Previous Entries # $ #3 3Ñ(#) Trig and Logarithms %BA After an expression is evaluated, use # and $ to scroll through previous entries, which are stored in the TI-34 Ö memory. You cannot retrieve previous entries while in STAT mode. remainder(#1, #2) Last Answer %i Integer Divide %Y The most recently calculated result is stored to the variable Ans. Ans is retained in memory, even after the TI-34 Ö is turned off. To recall the value of Ans: ¦ Press % i (Ans displays on the screen), or ¦ Press any operations key (T, U, F, etc. ) as the first part of an entry. Ans and the operator are both displayed. % Y divides 2 positive integers and displays the quotient, Q, and the remainder, R. Only the quotient is stored to Ans. % B displays a menu of all trigonometric functions (sin, sin -1, cos, cos-1, tan, tan-1). Select the trigonometric function from the menu and then enter the value. Set the desired Angle mode before starting trigonometric calculations. You must press < or $ to save the last data point or FRQ value entered. If you add or delete data points, the TI-34 Ö automatically reorders the list. When all points and frequencies are entered: ¦ Press u to display the menu of variables (see table for definitions) and their current values, or ¦ Press v to return to the blank STAT screen. You can do calculations with data variables (Ï, Ð, etc. ). Select a variable from the u menu and then press < to evaluate the calculation. Notation %‚ C % ‚ displays the decimal notation mode menu. These settings only affect the display of results. F (default) restores Floating-decimal format. Set decimal places to n (0–9) with 0123456789. C enters a value in scientific notation. Press M before entering a negative exponent. 7. When finished: ¦ Press % t and select CLRDATA to clear all data points without exiting STAT mode, or ¦ Press % w < to clear all data points, variable and FRQ values, and to exit STAT mode (STAT indicator turns off). the valid range. [. . . ] Separate the 2 integers with a comma. Review instructions to be certain calculations were performed properly. Check the battery to ensure that it is fresh and properly installed. Change the battery when: ¦ & does not turn the unit on, or ¦ The screen goes blank, or ¦ You get unexpected results. To continue using the TI-34 Ö† until you can change the battery: 1. Expose the solar panel to brighter light. [. . . ]