User manual ASUS EEE PC 8G XP

[. . . ] Unlock and hold the latch, and remove the battery . Replacement CPU . Remove 6 screws(M2*4L(K)) and take the Fan bracket away. 2. Disconnect the FAN connector and remove 2 screws(M2*4L(K)) then take away the Fan Module. 5-2 W3A upgrade & replacement 3. [. . . ] Remove the 4 screws (M2*4L(K)) upon the thermal module and take away the CPU heat sink module gently 4. Turn the non-removable screw here 180 degrees counter-clockwise to loosen the CPU and take the CPU away Note: If thermal module has no thermal pad on it, please plus a thermal pad on the CPU die before assembling. Installing CPU 1. Use the CPU vacuum to "suck up" the CPU then then Install the CPU and turn the non-removable screw here 180 degrees clockwise to lock the CPU. 2. Install the CPU heat sink module gently and secure 4 screws (M2*4L(K))upon the CPU module . + 5-3 W3A upgrade & replacement M2*4L 3. Finally, put on the fan bracket and secure 2 screws (M2*4L(K)). M2*4L 4. Put the CPU Module cover on then secure 6 screw (M2*4L(K)) to fix it. Install battery module . 1. Put the battery module into its compartment. 5-4 W3A upgrade & replacement MEMORY Memory Upgrade The W3000A Series Notebook does not have onboard RAM. Connect the keyboard FPC cable and place the keyboard on the top case (make sure the 3 latches are holding the keyboard firmly). 6. Secure 2 screws (M2*4L(K)) 5-8 W3A upgrade & replacement Install battery module . Put the battery module into its compartment. HDD HDD Upgrade TheW3000A Series Notebook uses an industry-standard 2½" HDD with IDE interface. You can replace the HDD to any capacity of your choice within our approval and prior test. Replacing HDD Remove battery module 1. Turn the notebook over. Unlock and hold the latch, and remove the battery . 5-9 W3A upgrade & replacement HDD MODULE REMOVAL Replacement HDD Module 1. Remove 1 screw (M2*4L(K)), then remove the HDD door. M2*4L 2. Lift the hard disk module and disconnect the FPC then take away the hard disk module. Installing new HDD module. 1. Insert the hard disk module and connect the FPC then lay it down then push it until it's installed properly. Put on the hard disk cover and secure 1 screw (M2*4L(K)). 5 - 10 W3A upgrade & replacement M2*4L Install battery module . Put the battery module into its compartment. ODD ODD Module Replacement Replacing ODD Remove original ODD module Press latch here then pull it out. Install original ODD module Insert the optical drive module to its compartment. 5 - 11 W3A upgrade & replacement WLAN WLAN Module Replacement This slot usually has Wireless LAN module when leaving the factory, this slot is for optional system upgrade. [. . . ] Put on the hard disk cover and secure 1 screw (M2*4L(K)). 5 - 10 W3A upgrade & replacement M2*4L Install battery module . Put the battery module into its compartment. ODD ODD Module Replacement Replacing ODD Remove original ODD module Press latch here then pull it out. Install original ODD module Insert the optical drive module to its compartment. 5 - 11 W3A upgrade & replacement WLAN WLAN Module Replacement This slot usually has Wireless LAN module when leaving the factory, this slot is for optional system upgrade. Replacing WLAN module 1. Remove battery module . Unlock and hold the latch, and remove the battery . Replacement Wireless LAN Module 1. [. . . ]