User manual ASUS ET2400IGKS

[. . . ] The socket outlet should be installed near the equipment and be easily accessible. · This product should be operated from the type of power indicated on the marked label. If you are not sure of the type of power available, consult your dealer or local power company. Care And Cleaning · Cleaning. Always unplug your monitor from the wall outlet before cleaning. [. . . ] Lower resolutions are displayed on a full screen through an interpolation circuit. Image blurring across pixel boundaries can occur with the interpolated resolution depending upon the image type and its initial resolution. To take full advantage of LCD technology you should select the native resolution setting of 1920 x 1200 on your PC screen resolution setting as described below. Be aware that not all PC video cards provide this resolution value. If your doesn't, check with the video card manufacturer's website for an updated driver for your particular model PC video card which supports this resolution. Software video drivers are often updated and available for new hardware video resolutions. If necessary, you may need to replace and update the PC video card hardware to be able to support the native resolution of the monitor. 1. Open Display Properties and select the Settings tab. You can open Display Properties by right-clicking on the Windows desktop and selecting Properties from the pop-up menu. 2. Use the slider in the `Screen area' section to adjust the screen resolution. Select the recommended resolution of 1920 x 1200 then click Apply. If you select some other resolution, be aware that this other resolution is interpolated and may not accurately display the screen image as well as it could do at the native resolution setting. 3. Close the Display Properties window. How to adjust the screen resolution 23 6. How to adjust the screen refresh rate You don't have to choose the highest possible refresh rate on an LCD display, because it is not technically possible for an LCD display to flicker. The best results are obtained by using the factory modes already set in your computer. The key is also the hot key for activating the PIP (Picture-in-Picture) function and selecting a video input source for the PIP window. 4. t (Up) key: For Up/Increase adjustment. The key is also the hot key for Brightness. u (Down) key: For Down/Decrease adjustment. The key is also the hot key for Contrast. 5. "MENU/EXIT" key: Activate OSD main menu and return to the previous menu or exit OSD. "Mode" key: Switch between different modes, including Standard, Movie, Dynamics, and Photo. "Input /Swap" key: Manually switch between different video signals that may be connected to your monitor for the main window, or swap the input signals between the main window and the PIP window. "AMA Z" key: Activate the AMA Z function. It is recommended that you use this function specially when you are viewing dynamic contents, such as movies, games, etc. "i key": Adjust vertical position, phase, horizontal position and pixel clock automatically. OSD = On Screen Display. [. . . ] If the image is still not correct and the OSD also has faulty coloration, this means one of the three primary colors is missing in the signal input. If any pin is bent or broken off, please contact your dealer to get necessary support. No image can be seen: Is the prompt on the display illuminated in green? If the LED is illuminated in green and there is a message "Out of Range" on the screen, this means you are using a display mode that this monitor does not support, please change the setting to one of the supported mode. Please read "Supported PC Timings on page 45" section. Recommended mode is 1920 x 1200 @ 60Hz. Faint shadow from the static image displayed is visible on the screen: · Activate the power management function to let your computer and monitor go into a low power "sleep" mode when not actively in use. [. . . ]