User manual ASUS K8

[. . . ] Position the CPU above the socket such that the CPU corner with the gold triangle matches the socket corner with a small triangle, while making sure that the CPU is parallel to the socket. Carefully insert the CPU into the socket until it fits in place. DO NOT force the CPU into the socket to prevent bending the pins and damaging the CPU. [. . . ] If you are using IDE hard disk drives, connect the IDE signal cable. Make sure the side of the cable with the colored stripe is plugged into pin 1 of the IDE connector. If you're using SATA hard disk drives, connect the SATA signal cable. The SATA connector fits only in one orientation. If the connector doesn't fit, try reversing it. Floppy disk IDE Serial ATA 6 Connect the chassis LED and power switch cable On the front of your chassis, you will find some LED and power switch leads. Connect these leads to the panel connector on the motherboard. LED and switch leads 7 Install expansion cards 1. Remove the slot covers from the chassis where you wish to install the expansion cards. Install your AGP graphics card in the proper slot. Install other expansion cards using the same procedure. PCI card AGP card Wi-Fi card 7 English English 8 8 Connect the power supply cables The plugs from an ATX power supply are designed to fit the power connectors on the motherboard. Orient the 20-pin power plug such that the plastic clip on the side matches the plastic tab on motherboard power connector. The plug is in place when the clip snaps over the tab. Follow step 1 to connect the 4-pin ATX 12V power plug. [. . . ] · Check the floppy drive cable, make sure it is connected properly. · Check the drive configuration in the BIOS setup. · Check the IDE drive cables, make sure they are corrected properly. [. . . ]