User manual ASUS KR EXTERNAL HDD

[. . . ] Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications. [. . . ] So, you can select only one default recording source at a time. You may have to restart the recorder program if you switch to a different source. (Note: On Vista, some application programs may allow you to select the recording device/path in the recording programs themselves. ) Drag this slider down to decrease the recording volume; drag up to increase the recording volume. The tool-tip reveals the percentage number from 1 to 100 in terms of the full scale level. This horizontal slider controls the volume between the left and right channels. Reset all volume controls to the default settings Click this button Microphone-In: to open the advanced settings for the 5 Recording Volume Slider 6 7 8 Left/Right Balance Reset Microphone-In Advanced Setting You can check with “Front Panel Microphone” to enable microphone of front panel. enabling “Microphone Boost” will increase a volume gain to boost microphone input signals. For typical low-cost PC microphone, it’s recommended to enable this function. 1 Effects Environment Effects Environment effects can be used to create realistic listening experiences that mimic different environments. There are a total of 27 environment options, which can be applied to all 2D sound sources, like music. Select the speaker type that you connected. If your speaker type cannot perform low-frequency signals (bass), please select “Small” speaker type and Xonar DX will filter out the bass signals and send them to the subwoofer channel. If those speakers are full-range, you can select the “Large” speaker type. Note: Common, cheap PC’s 2-channel speakers are usually small-type speakers. please refer to the speaker’s specification. If you have any questions, please consult your speaker vendor. 1 speakers with a subwoofer should be categorized as Large speakers because the subwoofer can redirect the bass signals inside the two channels to the subwoofer speaker automatically. 3 Picture for Small/ Large speaker Colors for small/large speakers are different. Orange: large speakers Green: small speakers ASUS Xonar DX 37 4 LFE Crossover Frequency Adjusts the cut-off frequency (50~250Hz) for LFE (lowfrequency effects) signals. Xonar DX will filter out the bass signals below the crossover frequency from small speaker channels and forward them to the subwoofer. The higher the crossover frequency, the more bass signals will be subtracted. [. . . ] in addition , Xonar DX supports unique DS3D GX 1. 0 on Windows Vista, which can recover DirectSound 3D hardware and EAX gaming sound effects on Vista for a lot of existing DirectX games. Q2: Why does the Xonar DX support Dolby technology?Answer: Dolby is the ONLY brands and technology recognized by the CE industry and available on a wide range of audio equipment. [. . . ]