User manual ASUS M4A785TD-M EVO

[. . . ] AMD-K6/233¡ ] . 2V¡ ^ 3 OFF ON ON ON OFF OFF ON ON OFF ON OFF OFF ON OFF OFF OFF OFF ON OFF ON ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF 23. Cyrix/IBM6X86-PR120+¡ ] 00MHz¡^ ON 1 24. Cyrix/IBM6X86-PR150+¡ ] 20MHz¡^ ON OFF OFF ON 1 25. Cyrix/IBM6X86-PR166+¡ ] 33MHz¡^ OFF ON OFF ON 1 26. [. . . ] Enter the information directly from the keyboard and press <Enter>. Those information should be provided in the documentation form your hard disk vendor or the system manufacturer. number of cylinders HEADS number of heads PRECOMP write precomp LANDZONE landing zone SECTORS number of sectors If a hard disk has not been installed select NONE and press <Enter>. · Drive A type / Drive B type The category identify the types of floppy disk drive A or drive B that has been installed in the computer. No floppy drive installed 5-1/4 inch PC-type standard drive; 360 kilobyte capacity. 5-1/4 inch AT-type high-density drive; 1. 2 megabyte capacity (3-1/2 inch when 3 Mode is Enabled). 3-1/2 inch double-sided drive; 720 kilobyte capacity 4-6 BIOS Configuration · 3-1/2 inch double-sided drive; 1. 44 megabyte capacity. Floppy 3 Mode Support (for Japan Area) Disable Drive A Drive B Both Normal Floppy Drive. Drive A & B are 3 mode Floppy Drive. 1. 44M, 3. 5 in. · Video The category detects the type of adapter used for the primary system monitor that must matches your video display card and monitor. Although secondary monitors are supported, you do not have to select the type in setup. EGA/VGA CGA 40 CGA 80 MONO Enhanced Graphics Adapter/Video Graphics Array. For EGA, VGA, SVGA, or PGA monitor adapters Color Graphics Adapter, power up in 40 column mode Color Graphics Adapter, power up in 80 column mode Monochrome adapter, includes high resolution monochrome adapters · Halt on The category determines whether the computer will stop if an error is detected during power up. Enabled Disabled Floppy A & B will be swapped under DOS Floppy A & B will be normal definition · Boot Up Floppy Seek During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360 K type is 40 tracks while 720 K, 1. 2 M and 1. 44 M are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks, Note that BIOS can not tell from 720 K, 1. 2 M or 1. 44 M drive type as they are all 80 tracks 4-10 BIOS Configuration · BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360 K Boot Up NumLock Status The default value is On. On Off Keypad is number keys Keypad is arrow keys Disabled · Typematic Rate Setting The default value is Disabled. Enabled Disabled Enable Keyboard typematic rate setting. Disable Keyboard typematic rate setting. · Typematic Rate (Chars/Sec) The default value is 6. 6-30 Set the maximum typematic rate from 6 chars. per second. · Typematic Delay (mSec) The default value is 250. 250-1000 Set the time delay from first key to repeat the same key in to computer. · Security Option This category allows you to limit access to the system and Setup, or just to Setup. System Setup The system will not boot and access to Setup will be denied if the correct password is not entered at the prompt The system will boot, but access to Setup will be denied if the correct password is not entered at the prompt M To disable security, select PASSWORD SETTING at Main Menu and then you will be asked to enter password. [. . . ] Initialize floppy disk drive controller and any drives. Initialize hard drive controller and any drives. Initialize any serial and parallel ports (also game port). Initialize math coprocessor. 4F 50 51 52 Reboot if Manufacturing POST Loop pin is set. Otherwise display any messages (i. e. , any non-fatal errors that were detected during POST) and enter Setup. [. . . ]