User manual ASUS P30A

[. . . ] Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. · Adobe and Acrobat are registered trademarks of Adobe Systems Incorporated. · Adaptec, AHA, EZ-SCSI, and AIC is a registered trademark of Adaptec, Inc. · Sound Blaster, SB16, AWE32, AWE64D and SB-LINK are trademarks of Creative Technology Ltd. [. . . ] Server Left Side Power Supply Motherboard Chassis Intrusion Switch Chassis Stabilizer (shown recessed) Expansion Card Guide Rear Fans AP 3000 Hardware Reference Guide 15 Left Side Back Side Back Side III. Starting the Server Turn ON the server by pushing the power button. The power button will snap back when released because ATX power systems have an electrical ON/OFF switch unlike AT systems which require a permanent ON or OFF position. If the Power On LED does not light, make sure the power cord is connected to the system unit and to a working grounded outlet. IMPORTANT The power switch only turns off DC power (power supply output). To turn off AC power (power supply input), you need to unplug the electrical cord from the outlet. · 3-2. LEDs There are two LEDs on the top left-hand corner of the front panel. The upper one is the power LED and the lower one is the hard drive access LED. When the system is booted, the power LED is green. When the hard drive is being accessed, the hard drive access LED is green. LEDs Power LED Power Switch Hard Drive Access LED III. The fan control board's cable connections are shown below. Fan Fan Power Connectors Reserved Connector Power Input Connector Fan Control Settings Reserved Fan Connectors IV. Hardware Setup Fan Status Signal Connector The rear fan control board has DIP switches to allow controlling the control board status and the number of fans. DIP Switch SET1 Fan Control Board Setting ON (momentarily) Reset Control Board OFF Normal (Default) SET2 SET3 ON ON ON ON ON ON OFF OFF OFF OFF OFF OFF ON ON OFF OFF SET4 ON OFF ON OFF ON OFF ON OFF Number of Fans 1 2 (Default) 3 4 5 6 7 8 AP 3000 Hardware Reference Guide 19 Rear Fans Rear Cooling Fan Control Board Settings IV. Motherboard You can remove the extended expansion card guide before installing or removing the motherboard. All screws are necessary to provide the needed stabilization to support all the motherboard expansion cards used in this chassis. Motherboard Spacers Place four spacers in the areas circled on the chassis. Extended Expansion Card Guide Spacer Install the Baseboard A metal baseboard is required to add stability to the motherboard. A rubber pad is placed between the metal board and motherboard to provide insulation to prevent shorting. Align the rubber pad over the metal baseboard so that the holes match. Align the XG-DLS motherboard over the rubber pad and metal baseboard so that the screws match up with the motherboard's screw holes. IV. Hardware Setup Motherboard Place and tighten three captive nuts in the corner locations circled. Motherboard Screws Place nine screws in the areas circled on the motherboard. The four screws used with the motherboard spacers are longer than the others. (See page 22 for samples. ) Be careful not to overtighten the screws. Doing so may damage your motherboard. 20 AP 3000 Hardware Reference Guide IV. [. . . ] Currently, there are socket 7, slot 1, and slot 2 CPUs. Intel Pentium Processors fit on socket 7, Intel Pentium II fit on slot 1, and Intel Xeon fit on slot 2. FDISK (Fixed Disk Setup Program) An MS-DOS program used to partition the hard disk drive. FDISK is required to setup a new non-RAID hard disk drive before formatting and installing an operating system. [. . . ]