User manual ASUS P4C800 DELUXE

[. . . ] P4C800 Deluxe User Guide Motherboard E1224 Checklist First Edition V1 April 2003 Copyright © 2003 ASUSTeK COMPUTER INC. No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK COMPUTER INC. Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing. ASUS PROVIDES THIS MANUAL "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. [. . . ] These POST messages are customizable using the Winbond Voice Editor software that came with your package. You can record your own messages to replace the default messages. Following is a list of the default POST messages and their corresponding actions, if any. POST Message No CPU installed System failed CPU test Action · Install an Intel Pentium 4 Processor into the CPU socket. · Check the CPU if properly installed. · Call ASUS technical support for assistance. See the "ASUS contact information" on page x. · Install 184-pin unbuffered PC3200/2700/2100 DIMMs into the DIMM sockets. · Check if the DIMMs on the DIMM sockets are properly installed. · Make sure that your DIMMs are not defective. · Refer to section "2. 5 System memory" for instruction on installing a DIMM. · Install a PCI VGA card into one of the PCI slots, or a +0. 8V/1. 5V AGP card into the AGP slot. · Make sure that your VGA/AGP card is not defective. · Check your CPU settings in BIOS and make sure you only set to the recommended settings. System failed memory test System failed VGA test System failed due to CPU over-clocking 3-2 Chapter 3: Powering up POST Message No keyboard detected Action · Check your keyboard if properly connected to the purple PS/2 connector on the rear panel. · See section "1. 4. 1 Major components" for the location of the connector. · Make sure you have connected a floppy disk to the floppy disk connector on the motherboard. · See section "2. 8 Connectors. " · Make sure you have connected an IDE hard disk drive to the one of the IDE connectors on the motherboard. · See section "2. 8 Connectors. " · Check CPU fan if working properly. · Check the CPU fan and make sure it turns on after you applied power to the system. · Make sure that your CPU fan supports the fan speed detection function. · Check your power supply and make sure it is not defective. · Call ASUS technical support for assistance. [. . . ] Press <Ctrl-Y> to save the selection and start the duplication. The following message appears: Start to duplicate the image. . . (Yes/No) Y - Continue N - Abort 5-28 Chapter 5: Software support 8. When the duplication process is completed, a message appears confirming that your Security array has been created. [. . . ]