User manual ASUS V3-P5V900 V SERIES P5V900 USER’S MANUAL(ENGLISH)

[. . . ] Remove the front panel assembly, then set aside. 3 4 Air duct 1 2 1 3 3 4 4 2 Chassis tab holes 3 Installation manual Installing a CPU Installing an Intel® Pentium® 4 CPU in the LGA775 package 1. Locate the CPU socket on the motherboard. Press the load lever with your thumb (A), then move it to the left (B) until it is released from the retention tab. CAUTION. To prevent damage to the socket pins, do not remove the PnP cap unless you are installing a CPU. [. . . ] To prevent damage to the socket pins, do not remove the PnP cap unless you are installing a CPU. 4. Lift the load lever in the direction of the arrow to a 135º angle. Lift the load plate with your thumb and forefingertoa100ºangle(4A), thenpushthe PnP cap from the load plate window to remove (4B). 3 4B PnP cap Load plate 4A 5. Position the CPU over the socket, making sure that the gold triangle is on the bottom-left corner of the socket. Fit the socket alignment key into the CPU notch. Gold triangle mark Alignment key 6. Close the load plate (A), then push the load lever (B) until it snaps into the retention tab. A B Installation manual Installing an AMD CPU 1. Locate the CPU socket, then lift the socket lever to a 90º angle. Install the CPU to the socket, making sure that the CPU corner with the gold triangle matches the socket corner with a small triangle. Push down the socket lever to secure the CPU. 1 2 3 CAUTION: Incorrect installation of the CPU into the socket may bend the pins and severely damage the CPU! Installing the CPU fan and heatsink assembly Installing an Intel® Pentium® 4 CPU heatsink and fan 1. Place the heatsink on top of the installed CPU, making sure that the four fasteners match the holes on the motherboard. Push down two fasteners at a time in a diagonal sequence to secure the heatsink and fan assembly in place. When the fan and heatsink assembly is in place, connect the CPU fan cable to the connector on the motherboard. B A A B 1 1 Installation manual Installing an AMD CPU heatsink and fan 1. Place the chassis upright, then remove the upper 5. 25" drive bay metal plate cover. Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the optical drive with two screws on both sides of the bay. Connect the IDE (A) and power (B) plugs to connectors at the back of the drive. A 3 2 3 3. Place the chassis upright, then remove the lower 3. 5" drive bay metal plate cover. Insertthefloppydiskdrivetothe bay, then carefully push the drive until its screw holes align with the holes on the bay. Securethefloppydiskdrivewith two screws on both sides of the bay. Connect the signal (A) and power (B) plugs to connectors at the back of the drive. 3 2 3 3. Place the chassis upright, then remove the upper 3. 5" drive bay metal plate cover. Insert the hard disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. [. . . ] Connect the signal (A) and power (B) plugs to connectors at the back of the drive. 3 2 3 3. Place the chassis upright, then remove the upper 3. 5" drive bay metal plate cover. Insert the hard disk drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the hard disk drive with two screws on both sides of the bay. Installation manual 3 3 2 3. 4. For SATA HDD: Connect the SATA signal and power plugs to the connectors at the back of the drive. [. . . ]