User manual ASUS VB195TL

[. . . ] Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. · Intel, LANDesk, and Pentium are registered trademarks of Intel Corporation. · IBM and OS/2 are registered trademarks of International Business Machines. · Symbios is a registered trademark of Symbios Logic Corporation. [. . . ] If you have more than one legacy ISA card in your system that requires to use this address range, you can increase the block size to either 8K, 16K, 32K, or 64K. If you are using an ICU to accomplish this task, leave ISA MEM Block BASE to its default setting of No/ICU. SYMBIOS SCSI BIOS (Auto) The default uses Auto settings for the onboard SCSI BIOS. If you do not want to use the onboard SCSI BIOS, choose Disabled. USB Function (Disabled) The motherboard supports Universal Serial Bus (USB) devices but current operating systems do not. If you have the necessary support disks and USB devices, set this function to Enabled to use the onboard USB connector. USB IRQ (Auto) When USB devices are connected to the onboard USB connector, the resource settings or IRQs for these devices are, by default, automatically assigned by the BIOS. You may manually select the settings: 5, 7, 9, 10, 11, 12, 14, and 15. If you are not using any USB devices, you may set this field to N/A. ONB VGA BIOS First (No) This allows you to select whether you want to use the onboard VGA BIOS as the primary VGA BIOS. No allows external VGA cards to take precedent when detected. Supervisor Password sets a password that will be used to protect the system and the Setup utility; User Password sets a password that will be used exclusively on the system. By default, the system comes without any passwords. To specify a password, highlight the type you want and then press <Enter>. A password prompt appears on the screen. Taking note that the password is case sensitive, and can be up to 8 alphanumeric characters long, type in your password and then press <Enter>. The system confirms your password by asking you to type it again. After setting a password, the screen automatically reverts to the main screen. 4. 11. 1 Forgot the Password? If you forgot the password, you can clear the password by erasing the CMOS Real Time Clock (RTC) RAM. The RAM data containing the password information is powered by the onboard button cell battery. To erase the RTC RAM: (1) Unplug your computer, (2) Short the solder points, (3) Turn ON your computer, (4) Hold down <Delete> during bootup and enter BIOS setup to re-enter user preferences. WARNING!Move the jumper to the "Clear CMOS" setting only when clearing RTC data. Otherwise, BIOS setup information may be cleared. R RTCLR 3 2 Battery test 1 Normal Setting (Default) VB195TL Real Time Clock (RTC) RAM RTCLR 3 2 1 Clear CMOS ASUS VB195TL User's Manual 59 4. [. . . ] UltraDMA/ 33 IDE devices can achieve up to 33MB/Sec transfer. LPT Port (Line Printer Port) Logical device name reserved by DOS for the computer parallel ports. Each LPT port is configured to use a different IRQ and address assignment. APPENDIX Glossary 110 ASUS VB195TL User's Manual 7. [. . . ]