User manual ASUS VW22ASL

[. . . ] It can be displayed up to three (3) times. Make sure to adjust the resolution of your PC before reaching the maximum count. Note The resolution displayed on the screen is the optimal resolution for this product. Adjust your PC resolution so that it is the same as the optimal resolution for this product. Front 10 Introduction MENU button [MENU/ ] Opens the on-screen menu and exits from the menu. [. . . ] Set the video card by referring to the video card manual. The screen suddenly has become unbalanced. Q: A: Q: Have you changed the video card or the driver?Adjust screen image position and size using the OSD. Have you adjusted the resolution or frequency to the monitor?57 Troubleshooting A: Adjust the resolution and frequency at the video card. Q: The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD. The screen is out of focus or OSD cannot be adjusted. Q: A: Have you adjusted the resolution or frequency on the monitor?Adjust the resolution and frequency of the video card. (Refer to the Preset Timing Modes). LED is blinking but no images on the screen. Q: A: Is the frequency properly adjusted when checking the Display Timing on the menu?Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes. (The maximum frequency per resolution may differ from product to product. ) There are only 16 colors shown on the screen. The screen colors have changed after changing the video card. Q: A: Have the Windows colors been set properly?Note If problems repeatedly occur, contact an authorized service center. {T190, T190G} Q&A Q: How can I change the frequency?The message may indicate that the monitor is out of scan range or that you need to check the signal cable. Environment The location and the position of the monitor may influence the quality and other features of the monitor. If there are any sub woofer speakers near the monitor, unplug and relocate the woofer to another room. Remove all electronic devices such as radios, fans, clocks and telephones that are within 3 feet (one meter) of the monitor. Useful Tips A monitor recreates visual signals received from the computer. Therefore, if there is a problem with the computer or the video card, this can cause the monitor to become blank, have poor coloring, become noisy, and video mode not supported, etc. In this case, first check the source of the problem, and then contact the Service Center or your dealer. Judging the monitor's working condition If there is no image on the screen or a "Not Optimum Mode", "Recommended Mode 1680 x 1050 60 Hz" message comes up, disconnect the cable from the computer while the monitor is still powered on. If there is a message coming up on the screen or if the screen goes white, this means the monitor is in working condition. In this case, check the computer for trouble. 61 Troubleshooting {T200, T200G, T220, VW22ASL} Check List Note Before calling for assistance, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the Information section or contact your dealer. No images on the screen. I cannot turn on the monitor. Q: A: Q: A: Is the power cord connected properly? [. . . ] Reboot the computer after installing the program for the first time. If a copy of the program is already installed, remove it, reboot the computer, and then install the program again. You need to reboot the computer for it to operate normally after installing or removing the program. Note Visit the MagicTuneTM website and download the installation software for MagicTuneTM MAC. I can see tiny amounts of alien substances when I look at the product edge closely. Q: This product has been designed so that the color appears faint by coating the black edges with transparent matter. [. . . ]