User manual AT&T 135

[. . . ] Use a ball point pen to set the switch to TONE if you have tone telephone service, or to PULSE if you have dial pulse (rotary) telephone service. Plug the free end of the line cord into a modular wall jack. Plug the coiled end into the handset jack on the side of the phone. Plug the other end of the coiled cord into the handset, then hang up. [. . . ] Flash Press instead of pressing the switchhook to activate customer calling services such as call waiting or three-way calling. You may have to press other buttons before or after as explained in custom calling instructions provided by your local telephone company. Ringer Volume The RINGER volume switch allows you to adjust the loudness of the telephone ringer from OFF to HI. Slide the switch to the desired volume level. Volume Buttons The VOLUME button adjusts the handset during your call. While on a call, press to increase volume, to decrease volume. Dial Mode This telephone has a selectable push-button dial and will work with either tone or rotary telephone service. It can be set to work directly with long distance or certain other services that require tone signaling including some tone activated computer systems. (Turn over for more Operation, Memory and In Case of Difficulty) 4 AT&T 135 Quark pdf 7/22/98 11:26 AM Page 6 OPERATION (continued) Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some toneactivated computer systems (e. g. , telephone banking). To change from pulse (rotary) to tone dialing during a call: 1. Dial a telephone number with the dial mode switch set to PULSE. Press ; all buttons pressed after this will send tone signals. After you hang up, the phone automatically returns to rotary service. MEMORY Memory Features Numbers will remain stored in memory unless you erase or change them by entering other numbers. Capacity: This telephone can store up to 9 different phone numbers, each up to 24 digits long. Speed Dialing: Nine telephone numbers can be stored in standard speed-dialing locations. You can dial any of these numbers by pressing two buttons. NOTE: You may choose to store emergency numbers in memory locations. This feature is provided only as a convenience and the manufacturer assumes no responsibility for customer reliance upon the memory feature. 5 AT&T 135 Quark pdf 7/22/98 11:26 AM Page 7 MEMORY (continued) Directory Card: Remove the directory card. Write your telephone number in the space provided. Also write the telephone numbers (or names) that you want to store in each memory location. [. . . ] If you have tone dialing service, you can use either tone or dial-pulse mode. If you set the switch to TONE, numbers are dialed much more quickly. Telephone Does Not Ring Make sure the Ringer switch is not set to OFF. If there are several other phones on the same line, try disconnecting some of the other telephones. [. . . ]