User manual AT&T 1719

[. . . ] 1719 Digital Answering System Fold open this manual for information about this product's installation and operation. Please also read Part 1 ­ Important Product Information. AT&T and the Globe Design are trademarks of AT&T Corp. licensed to Advanced American Telephones. © 2002 Advanced American Telephones. Issue 1AT&T 12/02 © 2002 Advanced American Telephones. [. . . ] You will need to reset the volume to the lowest setting. If you decide to speak with the caller, lift the handset of any telephone on the same Record Your Announcement Before using this answering system, you should record the announcement (up to three minutes long) that callers will hear when the system answers a call. If you choose not to record an announcement, the system answers with a pre-recorded announcement:"Hello. Please leave a message after the tone. " 1 Press and hold a. When the system beeps, speak toward the microphone normally, from about nine inches away. While you are recording, the Message Window blinks . 4 OPERATION line. The system stops recording and resets to answer calls. If the system doesn't disconnect immediately, press and release the telephone switchhook. Before playing each message, the system announces the day and time the message was received. If the clock wasn't set when the message was recorded, either because you didn't set the clock or because there was a power failure after you set it, the system will announce "Power Failure" after the time and day. After playing the last message, the system announces "End of messages. " Play messages -- Press P. If you have new messages, only the new messages will be played. If you have no new messages but have old messages, the old messages will be played. If you have no messages, the system announces "No messages. " Play message at half speed -- Hold down r while the message is playing. Play message twice as fast -- Hold down a while the message is playing. Repeat entire message -- Press and release r. Repeat previous message -- Press r twice, and continue this process to hear other previous messages. Skip to next message -- Press and release a. Stop message playback -- Press and release P. Caller ID Number Announce NOTE: For these features to work, you must subscribe to Caller Identification service from your telephone service provider. There is a fee for this service, and it may not be available in all areas. This system can announce the telephone number of a caller, between the second and third rings. (See Feature Setup and Feature Summary to turn this feature on). Store Number When this feature is on, the system will announce a caller's number when playing back a message. Accept Blocked Calls When this feature is set to OFF, the system will respond to "blocked" calls (those from callers who have chosen to block their numbers from identification) with the pre-recorded announcement, "We're sorry, blocked calls to this number cannot be accepted. " The system then hangs up without recording a message. [. . . ] Enter your Remote Access Code and delete some or all messages. Press * 0 to make sure system is on before hanging up. The system announces "The machine will now hang up, " and disconnects the call. Memory full End remote access call 8 I N C A S E O F D I F F I C U LT Y If you have difficulty operating this product, try the suggestions below. For Customer Service, visit our website at www. telephones. att. com or call 1 800 222­3111. [. . . ]