User manual AT&T 1739 DIGITAL

[. . . ] 1739 Digital answering system This manual contains information about this product's installation and operation. Please also read Part 1 - Important product information For customer service or product information, visit our website at www. telephones. att. com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268. © 2007-2009 Advanced American Telephones. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Advanced American Telephones, an Antonio, T 729. [. . . ] To check the clock, press O. NOTE: In the event of a power failure, see the instructions on the bottom of the unit to reset the clock. If the clock is not set, before playing messages, the system will announce "Time and day not set" each time. Record your announcement Before using this answering system, you should record the outgoing announcement (up to three minutes long) that callers will hear when the system answers a call. If you choose not to record an announcement, the system answers with a pre-recorded announcement: "Hello. Please leave a message after the tone. " . NN/SIP When the system beeps, speak towards the microphone at the lower right corner of the answering system, from about nine inches away. While recording, - flashes in the message window and ON/OFF blinks. The system NN/SIP automatically plays back the outgoing announcement. To review the outgoing announcement, press NN/SIP. NN/SIP To erase the outgoing announcement and return to the pre-recorded announcement, press DEETE while the announcement is playing. Caller can skip the outgoing announcement by pressing #. Record a memo A memo can be up to three minutes and will be stored as an incoming message. MEMO/REPET When the system beeps, speak toward the microphone at the lower right corner of the answering system. P/STOP nswer calls When the system answers a call, the caller hears the outgoing announcement followed by a beep. After the beep, the system begins recording the caller's message. A caller can leave a message of up to three minutes. If the message is longer than three minutes, or if the caller is silent for more than seven consecutive seconds, or if the system runs out of memory, the system beeps once and hangs up. Callers can skip the outgoing announcement by pressing #. all screening/intercept Turn on the answering system and set the volume control so you can hear the caller's message. If the number announce feature is on, the caller's telephone number will be announced. NOTE: If you listen to messages or change feature settings, the volume will automatically adjust to an audible level. It will be necessary to reset the volume to the lowest setting. If you decide to speak with the caller, lift the handset of any telephone on the same line. 5 Operation The system stops recording and you can answer calls. If the system does not disconnect immediately, press and release the telephone switch hook. aller ID number announce NOTE: You must subscribe to the caller ID service from your telephone service provider for this feature. [. . . ] In some cases, the system might be affected by the ringing system used by the telephone service provider. If the system's memory is full or the system is off, the system answers after 0 rings. If the system is in feature setup mode and a call comes in, it will not answer the call until you press P/STOP or the setup timeout has elapsed. When the memory is full, some saved messages must be deleted before new messages can be recorded. [. . . ]