User manual AT&T 210

[. . . ] 4 Set DIAL mode switch This product comes set in the Figure 2 tone (TT) mode. Make sure you choose the correct dialing method (TT or DP); touch tone dialing will not work if you have dial pulse service. 5 Connect handset to base Plug one end of the coiled handset cord into the handset, and the other end into the base. 6 Check for dial tone Lift the handset and listen for dial tone. [. . . ] NOTE: If the number is more than 31 digits long, no digits will be stored in the redial memory. Erasing Redial For privacy, you can erase the redial memory. Lift the handset, then press 1 and hang up. Flash Press FLASH instead of pressing the switchhook to activate custom calling services such as call waiting or 3-way calling. You may have to press other buttons before or after FLASH as explained in custom calling instructions provided by your local telephone company. 4 Mute While on a call, press PROG/MUTE to mute the microphone. The other party cannot hear you, but you can hear the other party. Press PROG/MUTE again to return to two-way conversation. Ringer Volume The RINGER volume switch allows you to turn the telephone ringer OFF, or set it to ring at LO or HI volume. You can dial or answer calls normally when the ringer is off. Other telephones in your home will still ring; they are not affected by the switch. Select Ringer Tone You can select from three different ringer tones. 3 Press 3 for Tone 1 ­OR­ Press 6 for Tone 2 ­OR­ Press 9 for Tone 3. 4 Press PROG/MUTE to save your selection. Receiver (Handset) Volume The RECEIVER volume switch on the side of the handset can be adjusted for a comfortable listening level. 5 Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some tone-activated computer systems (e. g. , telephone banking). To change from pulse (rotary) to tone dialing during a call: 1 Dial a telephone number with the DIAL switch set to DP (pulse). 2 Press t; all buttons pressed after this will send tone signals. 3 After you hang up, the phone automatically returns to rotary service. 6 MEMORY DIALING Memory Features This telephone can store up to 13 different phone numbers, each up to 21 digits long. Numbers will remain stored in memory unless you erase or change them by entering other numbers. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. Directory Card: Remove the directory card. Write your telephone number in the space provided. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. MEM 6 MEM 7 MEM 8 9 MEM TH IS NO . MEM MEM 1 MEM 2 MEM 3 MEM 4 7 5 One-Touch Dialing Three numbers can be stored in one-touch memory locations . You can dial these numbers by pressing one of the buttons marked with an emergency symbol (, or ). [. . . ] Make sure you choose the correct dialing method (TT or DP); touch tone dialing will not work if you have dial pulse service. If you have tone dialing service, you can use either tone or dial pulse mode. If you set the switch to TT, numbers are dialed much more quickly. You Can Hear the Other Party, but Other Party Can't Hear You · The Mute feature might be activated. [. . . ]