User manual AT&T 2300

[. . . ] USER'S MANUAL Part 2 2. 4 GHz Expansion Handset 2300 Please also read Part 1 -- Important Product Information © 2002 Advanced American Telephones. AT&T and the Globe Design are trademarks of AT&T Corp. [. . . ] licensed to Advanced American Telephones. Charging Stand NiCd battery pack 1 BEFORE YOU BEGIN Compatibility BEFORE YOU BEGIN 2 This AT&T 2300 expansion handset is compatible with the AT&T 2320, 2325, 2355 and 2365 telephones. You may add up to three expansion handsets to your compatible telephone, for a total of four handsets. If you try to install a fifth handset, registration will be blocked. About Handset Registration Each expansion handset must be individually registered with your AT&T 2320, 2325, 2355 or 2365 base. Registration happens automatically when you place this handset fully charged into your current base. The original handset that came with the base is automatically registered as Handset 1. Additional handsets will be assigned Handset 2, Handset 3 and Handset 4. You can rename the handsets by following the directions under "Handset Name" in the FEATURE SETUP section of your base telephone User's Manual. INSTALLATION Charging Stand Installation 1 Connect the power cord to an electrical outlet not controlled by a wall switch. Standard electrical outlet 3 INSTALLATION NOTE: Install the charging stand away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture. 2 Install the handset battery. Use only AT&T Battery 3301, SKU# 91076. INSTALLATION a) Remove battery compartment cover by pressing on indentation and sliding downward. b) Plug the battery pack connector into handset. Place the battery pack and wires in the compartment. c) Replace cover by sliding it on its track up over battery case until it snaps firmly into place. 3 4 5 Charge the handset battery. · Place the handset in the charging stand. · Charge the battery at least 12 hours. [. . . ] Plug the headset into the jack located on the right side of the handset (under the small rubber flap). Do not force the connection, but make sure the plug fits securely. 5 INSTALLATION You can remove the belt clip from the handset. a) Pull clip away from handset to remove. b) Press tabs on belt clip into slots on back of handset to reattach. FEATURE SETUP AND OPERATION FEATURE SETUP AND OPERATION 6 FOR INSTRUCTIONS TO SETUP AND OPERATE THIS EXPANSION HANDSET, REFER TO THE MANUAL THAT CAME WITH YOUR ORIGINAL BASE TELEPHONE. DEFAULT SETTING DEFAULT SETTINGS FUNCTION: Dial Method Handset Volume Ring Volume External Ring Pattern Internal Ring Pattern Key Click DEFAULT SETTING: Tone 2 6 0 1 ON 7 DEFAULT SETTINGS TECHNICAL SPECIFICATIONS TECHNICAL SPECIFICATIONS Frequency Range Channels 2400 MHz ­ 2483 MHz 95 864 kHz 23 dBm -92 dBm GFSK TECHNICAL SPECIFICATIONS Channel Spacing Output Power Sensitivity Modulation Operating Temperature 0°C ­ 40°C Base Unit Voltage Base Unit Voltage Handset Voltage 96 ­ 144 Vrms (AC Voltage, 60Hz) 9 Vdc (AC Adapter Output) 3. 6­ 4. 6 Vdc, 600mAh 8 [. . . ]