User manual AT&T 272

[. . . ] 1 USER'S MANUAL Part 2 Two-Line Memory Telephone 272 Please also read Part 1 -- Important Product Information AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones. © 2000 Advanced American Telephones. 850003518 Issue 1AT&T 5/00 CONTENTS INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Table/Desk Installation . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Plug the other end of the coiled cord into the handset. Lift the handset, press L on the base, and listen for a dial tone. If you do not hear a dial tone, turn to IN CASE OF DIFFICULTY. To determine which line is which, press L on the base and call one of your telephone numbers. If you hear a busy signal, Line 1 is the number you called. If Line 2 rings, it is the number you called. 6 7 Wall Installation L1 or L1/L2 jack L2 jack Thread line cord through groove so set lies flat Follow Steps 1 and 2 above. · If you have a two-line wall jack, use only the short line cord. Plug one end into the jack labeled L1 OR L1/L2 on the bottom of the telephone. Thread the line cord through the groove on the bottom of the telephone. · If you have two separate wall jacks, use the short line cord and one of the long cords. Plug one end of the short line cord into the jack labeled L1 OR L1/L2 on the bottom of the telephone. Plug one end of the long line cord in the jack labeled L2 on the bottom of the telephone. Thread the line cords through the groove on the bottom of the telephone. 5 INSTALLATION 4 Connect the line cord(s) to your modular wall jack(s) and mount the telephone on the wall jack. · If you have a two-line jack, plug the free end of the short line cord into a modular wall jack. Make sure the cord snaps firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely. · If you have two separate jacks, plug the free end of the long line cord into the jack where you are not mounting the phone (baseboard jack). Plug the free end of the short cord into the jack where you are mounting the phone. Make sure the cords snap firmly into place. Place the phone on the wall jack mounting studs and pull down until it is held securely. Follow Steps 5, 6, and 7 in "Table/Desk Installation. " 5 6 TELEPHONE OPERATION RINGER Line 1 Volume Control Directory Card Connect a conference call Line 1 Line 2 Put a caller on hold RINGER Line 2 Volume Control Receiver Volume Control Memory locations (may be used to store emergency numbers) Temporary Tone Flash Redial last number called Access numbers in telephone memory Touch Tone or Dial Pulse switch Program memory numbers 7 TELEPHONE OPERATION Making a Call Press L or l and lift the handset. You can dial your call manually or use the Memory Dialing feature (see "Dialing Memory Numbers" in the TELEPHONE MEMORY section of this manual). Answering a Call Each line has a different ringer tone to signal an incoming call. [. . . ] You can dial and answer calls normally with one or both switches set to OFF. Other telephones in your home will still ring; they are not affected by the switches on this phone. If this is the only telephone in your home, you will not hear any incoming calls while both ringers are off. However, the light next to one of the line buttons will always flash when you have a call. Receiver (Handset) Volume Use the receiver VOLUME switch on the side of the phone to adjust the handset volume to a comfortable listening level. 10 TELEPHONE MEMORY This telephone can store up to 12 telephone numbers (up to 21 digits each). Directory Card Remove the plastic cover from the directory card on the base. [. . . ]