User manual AT&T 5870

[. . . ] 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page II User's Manual Part 2 5. 8 GHz Cordless Telephone 5870 with Talking Caller ID/Call Waiting Please also read Part 1 -- Important Product Information © 2003 Advanced American Telephones. AT&T and the Globe Symbol are trademarks of AT&T Corp. , licensed to Advanced American Telephones. 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page III Visit us at www. telephones. att. com © 2003 Advanced American Telephones. AT&T and the Globe Design are trademarks of AT&T Corp. , licensed to Advanced American Telephones. Issue 1AT&T 05/03 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page V CONTENTS BEFORE YOU BEGIN . . . . . . . . . . . . . . . . [. . . ] To return to the call, press P. TELEPHONE OPERATION Base 1 Press H on the base to place a call on hold. The IN USE light goes on and the SPEAKER light flashes. Press H again or press K to return to the call. 2 After five minutes, the base will ring to remind you there's a call on hold. If you do not answer the ring, the call will be disconnected. 29 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 29 Temporary Tone Dialing If you have dial pulse (rotary) service, you can change from dial pulse to touch tone dialing during a call. 1 Make the call, and wait until it is connected. Keys pressed after this send touch tone signals. 3 After you hang up, the phone automatically returns to dial pulse (rotary) service. 30 TELEPHONE OPERATION 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 30 DISPLAY SCREEN MESSAGES SCREEN DISPLAYS: WHEN: INCOMING OUTSIDE CALL You have an incoming phone call (without Caller ID). INTERCOM FROM [PARTY NAME] You have an intercom call from [PARTY NAME], for example HANDSET 2. Once an intercom call is underway, the handsets will show the icons of the participating parties. Both this phone and another phone on this line are in use. The base refused to accept the handset, either because it is in use by six handsets, or the handset registrations on the base have been deleted. The handset has finished SEARCHING FOR BASE and has made the link. Another device of the phone system is using the telephone line; for example, if the base is using the line, the handsets will all show this message. The number of distinct unanswered calls with caller ID which have not been viewed in the calls log. A call has been on hold for five minutes; pick up the call again. The base is being powered by the spare battery rather than by AC from a wall outlet; check that the base is properly plugged in to a working electrical outlet. TELEPHONE OPERATION LOW BATTERY EXTENSION IN USE PARALLEL SET IN USE SEARCHING FOR BASE REJECTED BY BASE FOUND BASE LINE IN USE [XX] NEW CALLS CALL ON HOLD RING BACK!CHECK AC POWER 31 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 31 HANDSET ICONS THIS ICON: INDICATES Line In Use indicator On steady with no number next to it when another phone on this line is in use. On steady with one or more numbers next to it, indicating which extensions are using the line. For example, 12 indicates that Handset 1 and Handset 2 are on an outside call. Intercom indicator On steady with the extension numbers currently on an intercom call. For example, 02 indicates that the Base and Handset 2 are on an intercom call. Battery indicator When the handset is removed from the charger, this lets you know the level of charge in the battery pack, from FULL ( ) to EMPTY ( ). [. . . ] Follow the instructions under "Dial Mode (TONE/PULSE)" in the FEATURE SETUP ­ BASE section of this manual. · If you have touch tone service and you hear clicks while you are dialing, you'll need to set the dial method to PULSE. Follow the instructions under "Dial Mode (TONE/PULSE)" in the FEATURE SETUP ­ BASE section of this manual. PROBLEM If you are unable to operate special telephone services or other equipment requiring touch tone signals: SOLUTION If you have dial pulse (rotary) service, follow the directions under "Temporary Tone Dialing" in the TELEPHONE OPERATION section of this manual. 66 IN CASE OF DIFFICULTY 91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 66 CALLER ID Problem If the caller's name or phone number is not displayed: Solution · Make sure you subscribe to Caller ID service from your local telephone company. · Make sure the battery is charged. [. . . ]