User manual AT&T 6100

[. . . ] 3 Connect microphone and speaker cords. 4 6100_book_1ATT 11/25/00 12:37 PM Page 5 INSTALLATION Standard electrical outlet Modular telephone jack 1 Connect the telephone line cord. 3 Connect microphone and speaker cords. 4 5 Charge the handset battery. Charge the battery for at least 24 hours the first time. After the first charge, the battery is typically fully charged overnight. [. . . ] If you move out of range without pressing O, your phone will be left "off the hook. " To hang up properly, walk back into range, periodically pressing O. 11 6100_book_1ATT 11/25/00 12:37 PM Page 12 TELEPHONE MEMORY HEADLINE LEFT HEADLINE L-SUB This cordless phone can store 10 telephone numbers, each up to 16 digits long. You can dial numbers stored in memory just by pressing g and a number button. Store Memory Numbers 1 Make sure the handset is off. 3 Press the number button (0­9) where you want to store the telephone number. 4 Dial the telephone number (up to 16 digits) -- OR -- Press R to store the last number dialed. 5 Press g. Store a Pause in a Memory Number Press to store a two-second pause in the dialing sequence. Each press adds another twosecond pause and counts as one digit. Change/Replace a Stored Memory Number Store a new number in its place. Directory Label Dial Memory Numbers 1 Press P. 2 Press and release g, then press the number button (0­9) where the memory number is stored. Use the selfadhesive directory label to keep a record of the numbers (or names) stored in memory. It's best to write on the label before applying it to the phone. 12 6100_book_1ATT 11/25/00 12:37 PM Page 13 BATTERIES Charging the Handset Battery Pack This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours. The battery pack needs charging when: · A new battery is installed in the handset. · The phone beeps twice when you press P. · The phone light flashes slowly. Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours. You can keep the battery fully charged by returning the handset to the base after each use. If you repeatedly get a low battery indicator, even after eight hours of charging, the battery should be replaced. 13 6100_book_1ATT 11/25/00 12:37 PM Page 14 BATTERIES HEADLINE LEFT HEADLINE L-SUB Replacing the Handset Battery Pack 1 2 3 Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward. Lift out the old battery pack and disconnect. Align the two holes in the new battery pack's plug with the socket pins, and snap the plug into place. Place the battery pack in the compartment with the wires in the lower left corner, along the bottom of the battery pack. Replace the cover by sliding it up into place. The new battery pack must be charged before using the phone. [. . . ] Try moving the appliance or the base to another outlet. The layout of your home or office might be limiting the operating range. Try moving the base to another location, preferably on an upper floor. If the buttons don't work, try placing the handset in the base for at least 15 seconds. [. . . ]