User manual AT&T 7235

[. . . ] Connect the telephone line cord (see illustration). (If you are wall mounting the phone, wrap the excess cord in the groove on the bottom of the base. ) 8 3 Mount the base on the wall (wall mounting only). Hold the base so that the mounting knobs on the standard wall jack will fit into the holes on the bottom of the base. Slide the base down onto the knobs until it locks into place. [. . . ] NOTE: Each pause you store is counted as a digit. You can store up to 16 digits in each memory location. For example, to store 9, PAUSE, 555-1234 in memory location 3: Press p, 9, (hold the 9 for 2 seconds, until a second beep is heard. ) Then press 5 5 5 1 2 3 4 p 3. Dialing Speed-Dial Numbers 1 2 3 Press P. Press the number button (0-9) you assigned to the number you're calling. For example, to dial the number stored in location 9, press P, p, 9. Storing Numbers Just Dialed Whenever you make a telephone call, you can store the number you dialed in memory. Press R instead of entering the telephone number when storing speed-dial numbers. 4 BATTERIES Charging the Handset Battery Pack The batteries need charging when: · The phone beeps four times when you press P. · The LOW BATTERY light on the handset flashes on and off. · The phone does not respond when you press P, and no lights go on. Place the handset in the base so the CHARGING light goes on. The batteries will be fully charged in 10 hours. When the LOW BATTERY light goes on, place the handset flat in the base. NOTE: The handset must lie flat in the base, with the keypad facing down, when charging. A fully charged battery, under normal use, maintains standby power for up to 12 days when the Handset Ringer Control switch is set to ON, and up to 20 days when the Handset Ringer Control switch is set to OFF. If it's more convenient for you, you can leave the handset in the base all the time. It is impossible to overcharge the batteries. If you get a low battery indicator even after 10 hours of charging, the battery should be replaced. CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully. Replacing the Handset Battery Pack 1 Remove the battery case cover on the handset by pressing on the indentation and sliding the cover downward. Lift out the old battery pack and unplug it from the handset. Hold the new battery pack and plug the connector into the handset. Place the battery pack into the case, so the wires rest above the battery pack. Replace the cover by sliding it on its track up over the battery case until it snaps firmly into place. Charge the new batteries 10 hours before using the phone. Place the handset face down in the base and allow it to charge for 10 hours. [. . . ] · Pick up the handset, open the battery compartment, and unplug the battery pack. Wait 30 seconds, then reinstall the battery pack, close the battery compartment, place the handset in the base, and check to make sure the CHARGING light is on. Wait another 30 seconds, then pick up the handset and press P. The phone should operate properly. · · · · You Hear Other Calls · · Telephone Misdials · It might take a few seconds for your handset to find a good connection to the phone system. [. . . ]