User manual AT&T 7710

[. . . ] 2 User's Manual for 25-Channel Caller ID/Call Waiting Cordless Telephone 7710 NEW CALL CHAR /H GING ANDS ET IN USE PWR RESE RVE LOW BATT Fold open this manual for information about this telephone's installation and operation. Please read Part 1 -- Important Product Information, included in this package. PAGE HAND SET LOCA TOR Part 2 © 1998 Philips Consumer Communications L. P. Issue 1 AT&T 848233540 INSTALLATION Modular jack AC Adapter Power cord Telephone line cord FOR TABLE/DESK INSTALLATION 1 Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC). [. . . ] 4 Continue to select CHANGE to display ALL CALLS or NO CALLS. 5 Press MENU to exit. ID NOTE: If you try to use the Display Dial feature, but your call cannot be completed unless you dial "1" before the number, follow the steps below: 1 Press + or - to locate the number you want to call. 4 Select DIAL 1+. Programming Local Area Codes NOTE: You must program your home area code in order for the Display Dial feature to work correctly. Additionally, see Steps 4 and 5 in "Display Dial" for area codes that don't require dialing a "1" before them. Continue to select NEXT until the screen displays AREA CODE 1. Use the keypad to enter your home area code. Select CODE 2 to reach AREA CODE 2 (the screen displays any current local area code --those that do not require dialing a "1" before them-- stored here). Select CODE 3 to reach AREA CODE 3 (the screen displays any current local area code --those that do not require dialing a "1" before them-- stored here). Use the keypad to enter the three-digit local area code. Press MENU to exit. Incoming Call History This product assigns each incoming call a number from 1 to 99. The most recent call will have the highest number (for example, if 10 calls have been received, call number 10 is the most recent, and call number 1 is the oldest). When the call history is full, the oldest call information is deleted to make room for the new incoming call information. Reviewing Call History You can review information in the call history at any time by pressing either or . The screen displays the number of calls in the call history and how many, if any, are new. You can continue to use or to scroll through the call history. The screen displays the name (if your service provides this), number, date, and time of call simultaneously. When you reach the end of the call history, the screen displays END OF LIST. Press or to continue reviewing the call history. To exit the review, you can press either soft key or wait 30 seconds. 5 6 7 Removing Call Records from History Removing a Specific Call Record 1 2 3 Press or to scroll to the record you want to remove. The handset beeps and deletes the call record, and the screen displays CALL REMOVED. Press < or > to continue scrolling, or use the softkey to exit. Press or to display the number of calls in the call history. [. . . ] Press C to change to another channel. · To reset the security code, try the following: · Place the handset in the base, and check to make sure the CHARGING light is on. Wait 15 seconds, then pick up the handset and press P. Place the handset in the base, and check to make sure the CHARGING light is on. Unplug the AC adapter from the outlet, wait 15 seconds, then plug it in again. [. . . ]